44169 12-4 Fuel Injector Seal Kit, 1 Pack

I decided to test and clean the original injectors with test fuel injector cleaner and tested with 12v battery while pushing air through them. This rebuild kit fit prefect and was not over-priced. TIP: Easy way to remove your old screen is to use a wood screw flatten on end, place in vice and screw injector onto screw, then rock and pull out screen. install new screen and lightly tap with hammer until seated...

fit the injectors on my 92 MR2's 5SFE (part no 23250-74040). Same seals except these injectors don't use the pintle caps.HINT: the insulators (the really thick doughnut ones at the engine side) go in the engine first, then you insert the injectors into the insulators while they're on the fuel rail. (if you try it with the insulators on the injectors instead of in the engine they'll fall off)

Came with everything described and all fit perfect. Used some boiled water that I let cool a bit and dipped the Pintle tips into and hand pressed them on to the injectors with ease. Going on my 1986 toyota pickup.

kit installed just fine on 323k mile 22RE, truck runs and rails don't leak.

everything fit and it is working great, 85 Toyota 22re

Great kit for the price,just gotta figure out how to get the screens out of injectors now....

Doesn’t come with pintle caps despite being advertised as including them. Don’t bother.

my kit included pintle caps and they fit well, just as snug as the original ones. They needed to be installed using a heat gun