Antec Dark League DF700 Flux White, Mid Tower ATX Gaming Case, Flux Platform, 5 x 120mm Fans Included, ARGB & PWM Fan Controller, Tempered Glass Side Panel, High-Airflow Mesh Front Panel

This case looks amazing, the airflow is incredible, and the noise is quiet. Plenty of space for everything you need. It's a little larger than I expected, but not really an issue. Would purchase again in the future

I used this case to build my first PC and I think it came out great! Airflow could be better though, I had to block off the vents on the bottom right because the intake air from the front fans was going out those vents instead if taking air in. But overall I like it, included fans are nice but I put 3 140mm fans in front. Can fit a massive GPU in it too!

I would pick the same one again for the same build. Good quality great ventilation came with five fans RGB is great easily fit my huge XFX 7900 XTX. With room to spare if you’re on the edge, this is the one to get. I continue to shop for everything for weeks after I have bought something I still haven’t found anything I would have rather bought… Stop looking this is the one

This was my first PC build and I wanted some ARGB included with controller rather than daisy chain. I was able to simply hook everything to the controller then connect to the motherboard. Since I had 2 headers on the MB I then connected the air cooler so they are all in sync. It looks great but I think the rear fan should also be an ARGB as it would really stand out. I would of liked to have some grommets in the cable holes. Also beware that the bottom fan is left in place you may need to connect the case wires to the motherboard before installing it as it blocks the headers. Still very happy with the case

This case (which I have the white one) is a really good solid case for the price I Took my time. Ran the cables through the provided openings. nice no jagged edges FITS WELL. I have a water cooler mounted to the top( didn't want to mess with the installed fans and wiring) !! I took a start away on ease of assembly !! RESONS FOLLOW 1 the reverse fan (bottom) mount did not fit right so I left it out, TO TIGHT agents the ATX MB AND slightly over the power pack.. it would have worked good if the MB was a micro ATX then it would have fit find. Hint hint Antec ANTEC NEEDS TO AJUST REVERSE FAN MOUNT position A FEW INCHS TO THE RIGHT AND A LITTLE few MM TOWARDS THE FRONT PANEL 2 the wiring in the back was a bird nest. easily cleaned up though. I would buy it again even with the fan flaws and bird nest wiring job

The fans and fan hub included are a nice feature however there is no front mounted usb c on the model I have so for some people that could be an issue other than that its pretty much a standard layout mid tower case with no sharp metal edges

Super good case and its clean

It is a mid tower so tehre is plenty of space. my b650 alongside my 4070 fit in there with way more than enough space to spare. The front fans are rgb but the other two are not so be aware. I thought they were all rgb but that was my fault

It's a bit disappointing that the 2 fan,back and bottom, doesn't come with ARGB lights. Also, the back fan have a manufacturing defect. The arrows on the fan that are suppose to indicate the wind direction are wrong. Therefore, I had to unscrew that one and flip it. Finally, make sure to remove the plastic on the tempered glass (plastic protector on both side) because those are not scratches. ahah