Dorman 926-186 Passenger Side Turbo Coolant Line Kit Compatible with Select Ford/Lincoln Models (OE FIX)

I normally purchased the exact same product from my local suppliers. But the prices have gotten a little outrageous and their availability has a lot to be desired. When I ordered this part in the past it usually takes them a day if not a couple hours to get it. I had this shipped overnight and was able to do the repairs. Is parts wearing exact fit to OEM. I would definitely buy this product again

Better than OEM! Made from Stainless steel and have been work great. It’s now 2026 and I installed them in 2023 still doing good no leaks and stronger then oem. It says you must remove the turbos to install but I was able to maneuver and finagle to get them installed but still took me 4 hours to install both sides

If you are reading this review you need to replace the coolant lines on your Ecoboost- and that is no fun. I replaced my leaking exhaust manifolds with parts from BD Diesel- and decided to replace the coolant lines also. The old tubes were carbon steel- and getting corroded. These units from Dorman are stainless, and they have the fittings you need also. Along with the proper turbo inlet gaskets. This job is no fun- do not cut corners and re use any of these pieces. Ford really chose to cheap out with these crazy pushlock fittings, and they like to leak. Mine had 108000 miles on them, and replacing all these parts only makes sense. I guess Ford updated the entire coolant fitting parts in 2017- what does that tell you.....

Love these perfect fit for my turbos. Have been driving with them for 6 months already and no leaks

Installed onto 2017 3.5 ecoboost. All parts fit perfectly. Already have about 6,000 miles on the parts still no leaks.

Everything was in the box that I needed to be able to install these new lines. High quality lines show no leakage since I installed them. The installation was a challenge.

The rear coolant line that attaches to the back of the block is not the same as OEM. Unless you would like to bend it back and forth for hours until you can get it to fit I recommend you look for a different replacement. I have bent it so much and could not get it to fit I ended up ordering a different brand because I could not for the life of me get it to fit correctly. The one that is under the turbo fits correctly though.

Worked great. Decided to install these while I was dealing with manifold leaks on my 2016 Expedition. Good luck with the driver's side rear - had to cut a wrench in half to make it work.

Supplied as posted

Good