EZ Flares - Offroad Flexible Foam Rubber Fender Flares 1-inch Extension

First off this is a fantastic product for its price. I love the customization it adds to the look of my 4Runner on top of the extremely easy install and ruggedness of its appearence. The front flares were put on a week before and not a moment too late as hurricane Lane came through the Hawaii islands a few days later. I’ve got to say they do hold up well in heavily wet conditions. The structure of the product is pliable rubber, yet very resilient. I’ve gone through rough gravel patches with the front flares and so far the material is holding up better then expected. I was initially worried about the adhesive not being able to bond well but as long as you clean the surface throughly and make sure it is bone dry, I waited an hour after washing then used a heating gun to ensure the area was completely dry, there should be no issues with it coming off. This could be due to a miscommunication on my part but it was quite difficult to understand how much length acctually comes in the package so I did have to order a second set as the first only covered my front end. You should measure your area you want covered before hand then order depending on how long that may be. Overall I’m extremely satisfied with this product.

They gave my crossover suv a more off-road look. I've had them on for about 4 years now and they haven't peel, ripped, or deteriorated in any way. 5/5 for quality alone

This product is well made. Installing them took five minutes. The adhesive is very good. I installed them and I tried pulling them off. They would not Budge. However, I gave it 4 stars only because there is not much product. One spool, only did my front 2 wheel Wells. I have to purchase another one and I feel like that's too expensive for this product. Overall, it's a good product.I will write another review in a couple months to see how they hold up.

These are super easy to install. They look great and have kept the rock chips from dinging up my paint as my wheels extend beyond my vehicle exterior. I checked their site and these are sold to only cover 2 wheel wells per package. Definitely buy 2 unless your wheel wells are tiny. Looks great on my 97 Ford explorer instead of the old school looking Eddie Bauer flares. You can't tell they are soft till you touch them. Highly recommend mesuring length and cutting before installing. Make sure to cut with a sharp utility knife at a 30-60° angle on the ends otherwise it looks weird if it's straight as it curla down when stuck on. Hold it up and look to see what will work with the lines on your vehicle. I had about 2 smaller fenders left of material from the 2 packages.

I was so looking forward to this product. I refused to give up, but in order to not give up... I had to use Super Glue to adhere, I had to drill holes, screw and unscrew bolts. This product so underwhelmed me and now the super glue bleed to the outside so I always see it. Unfortunately, its already on my car until the carwash takes it off which I am assuming will be in a month or so. Save your money find other options or let it go. They say 3M adhesive, but I don't believe that I even had the blow dryer on high on it before placing and still had to use super glue.

Came out great and super easy. Took maybe 45 minutes to do my truck. Just be sure to clean the area good with alcohol buy 2 rolls. One roll only covers 2 fenders on my 2025 Ram 1500 warlock.

Simple & quick installation. I personally like the look of the product, gives your truck a more meaty appearance. Biggest disappointment...only came with enough material for two fenders. On my truck, it was almost not enough to cover the two. I had 2 inches left over & am now forced to spend more to finish over the other two fenders. Only complaint I have. I couldn’t find anywhere that indicated how much coverage you would get with this package. So do your research first.

It's really easy to install, as long as you do the prep Work, it requires you to heat the tablets with a hair dryer and clean the surface Really good. I used glass cleane with ammonia works good for me.

facile à poser et très discret

Ottimo per il tuning della vostra macchina

This product was purchased to fill a 1 inch overlap from my tires ( I purchased the 1" model flares ), I wasn't expecting the EZ Lip flares to be as amazing as they turned out, put it this way I was seriously doubting they would work, but now I'm seriously impressed with the ease of install and overall 'fit n finish'. genuinely impressed. I will certainly buy these EZ Flares again on any new project. USA OWNED and manufactured, a big thumbs up !!

Muy buen producto, me ha sorprendido, pensé que no duraría puesto y ahí siguen !!!

Bought these for my Lada Niva as I’d fitted 25mm spacers. These literally took 5 minutes to fit and actually look very good. Been on for 6 months and show no signs of wear or adhesive issues. Only comment is why sell in packs which are only enough for 2 wheels? It’s a bit misleading TBH