244166 Tub And Tile 2-Part Touch Up Paint, White

I ordered this to hide some cracking and peeling from a resurfaced tub and it was the perfect solution. The cracking was mostly over the grout lines and this filled those spaces perfectly. It was even great for small little dings and chips. I also used it on an area that was peeling on a tile and it filled in the space but you could see that it was a repaired - but only close up and not from a distance. This was a life saver from a a tub and tile surround resurfacing that didn't last as advertised (and of course the vendor went out of business). I didn't want to pay $3000 to have the tubs redone or replaced so this bought me years of additional service since the issues with the tub and tile were only cosmetic (ugly color) and not functional. My tubs were bright white and this was a perfect color match. I applied it like it was white out or nail polish. The smell is strong but just use a fan. I am extremely happy with this product!

This product worked well to cover up the area around my drain that was starting to rust. you can tell that the area has the paint on it but it looks 10x better then it did before. It will not make your tube look like new but is defiantly worth a try if you are just trying to fix a small issue. My only suggestion is to make sure you not only clean the area but to sand the rust areas really good before applying if that is the issue for you. i thought i had gotten all the rust off from one area but did not and now the rust is showing through the white paint so i will need to remove the paint and fix the rust issue then redo it.

I used this to repair two chips on a porcelain bathtub. Both were all the way through to the metal so there was rust that had to be cleaned off first. I used vinegar and salt to clean off as much of the rust as I could, then went over it with a little piece of 320 grit emery paper. Next I mixed the touch up kit and applied it with the supplied brush. The brush is small enough that you can precisely match the edges of the patch to the edges of the chip. However, it holds a surprising amount of the compound so (just like with paint) you have to be careful not to load up it up too much. The compound has approximately the same viscosity as correction fluid and I'm guessing would be difficult to use on anything other than a horizontal surface. Fortunately both of my chips were on the flat ledge surrounding the tub. After applying the compound I allowed three full days for it to cure before exposing the repairs to water. The cured product has a smooth finish, similar to the porcelain itself, although it is raised slightly above the surrounding surface. I suppose if you were really OCD you could do some wet sanding to achieve a perfectly level surface, but I didn't bother with this. So far the repairs have survived two long, hot showers and seem to be holding up well. The only thing preventing me from giving 5 stars is that the color match is not perfect; the compound is somewhat whiter than standard bathtub porcelain. But unless you look closely, it does not jump out at you. Once mixed, the compound must be used within 24 hours, so make sure you identify all needed repairs before beginning.

As everybody says, it’s bright white which wasn’t a true match, but since most of the areas I wanted to cover were small head-of-a-pin-sized holes it filled the holes neatly and they become invisible unless you know exactly where to look. The directions say to recoat after 10 minutes — I found that was too soon and got better results after 20 minutes. I found the brush in the cap too big for my use — wanted to just fill the dings, not coat the area around them — and found a toothpick was a much better, more precise application tool. It is also very runny immediately after mixing, which is fine for flat, horizontal surfaces. I had a few vertical surfaces and got better results when I’d let the paint sit for 15+ hours, with very little running because the paint thickens the longer it sits after mixing. By 24 hrs it was very thick and time to throw out what wasn’t used. An inexpensive solution that worked great.

there should be a better way to apply this maybe a sponge but the little nail brush would be OK for those who do their nails. As for the paint it seems to work OK but the existing color showed through at first but when dried it was gone, maybe it leveled out?

I used this epoxy paint to cover wear and some rust around the drain in a 50-year-old bathtub. Because of the rust, I first worked with sandpaper and steel wool to remove as much of the rust as possible. Then I did the mixing. The mixing of the A + B epoxy was easy. But follow the directions! The entire contents of the A bottle gets poured into the B bottle. (Each bottle starts out only partially full.) The inside of the lid of the B bottle has a little brush, which is the applicator. A second coat can be added 10 minutes after the first coat. After waiting another 10 min., I did a 3rd coat in some places to improve the look. I was done! The instructions say to wait overnight before getting the repair wet. I have used other types of tub touch-up kits in the past, but this product went on and looked better at application. Time will tell about Durability. If you are going to use one kit in various places in your home (such as 2 tub drain areas and a sink area), do the prep for ALL the areas before you mix the epoxy. Once you mix the epoxy, it begins the hardening process even if it is still in the bottle and the lid is tight. So be ready to work diligently as soon as you mix A with B.

First of all, the epoxy is less resilient than the Rust-Oleum appliance touch up, which does not have to be mixed and can be used for months, not within 24 hours. The appliance touch up is also a darker white, which matches way better. This stuff is super bright white. It stuck out like a sore thumb even on my super bright white bathtub. Cannot recommend.

Perfect match. Super easy to mix and gives the exact amount I needed.

One of the bottles arrived almost empty. The liquid was poured on the package. Waste of money.

Works great

Great for touch up. Levels quite well on drying and lasts - posted a year later

The white of this paint is so extreme it did not suit my vintage cast iron tub, and it required about five coats to cover the problems I was having with 15 minute drying in between, so this took quite awhile to complete. Not sure if this is the fault of the paint or my tub, but recently a new hole opened in the paint right next to where my previous repairs were. It definitely wasn’t a problem before. So perhaps this product still let in water that lifted the paint elsewhere. Regardless it has held up where I have applied it and that is more relevant I’m sure. Another negative is the smell and the small quantity for the price. Overall I’m glad to have bought it and used it to extend the life and functionality of my tub

Initially I thought it was fabulous- ( did shower recess ) but after a few showers it started flaking off.