Acquaer Shallow/Deep Well Jet Pump, Cast Iron Convertible Pump with Ejector Kit, Well Depth Up to 25ft or 90ft, 115V/230V Dual Voltage, Automatic Pressure Switch

Great value for the price. Works great on my shallow well. Easy to install.

My house pump went out and I was rushing to find a replacement. These were prime so I pulled the trigger.Connection was easy. Pump is extremely quiet and much more powerful than the pump it replaced. It runs smooth and is efficient. I purchased a second unit to keep as a backup that I have stored in my pumphouseThis is a great pump and has been flawless for a few months. If it dies in the next year, I’ll update this review. But for the price this unit is very well built and so quiet. Can not hear it running from the house (75’)

Very reliable, quiet and for half the price of its predecessor. I was also impressed with the plug in capabilities--- plug and pump.

Nicely made pump. Appears to be a quality piece. Previously, my well has had Gould J4 or J6 jet pumps. This was my first experience with a "two pipe" deep system. Unfortunately, I am right on the edge for lift with a single pump and the well casing is not sized to allow the second "deep" pipe for additional lift and PSI. Can't change the well casing so I will likely shelve the pump for some future project and seek out a unit with more lift from a single suction pipe. Disappointed but that is not the pump's problem....

This pump leaked like a sieve from the get-go, despite professional installation and re-installation. It failed from the start. The issue appears to be faulty machining between critical seams where the primary gasket fits. Fortunately we bought the Asurion coverage and are returning the item. Save yourself $ and headache and buy a better pump. Hopefully the Asurion return goes well - we have to package up the heavy item and take it to a shipper.

I bought this to use in the well at my house.I was very pleased with the performance of this well pump. And the pressure of the water is great.would recommend this to anybody.

This is the second pump from Acquaer .They are very well built.easy to install and is very quiet . had mine for 7 years and it never gave ma a problem until lighting hit it .Hope to get 10 good years out of this one .Thank you Acquaer.

Bought this pump to draw water from a canal to run yard irrigation. Installed the pump on a dock with 1-1/4” pvc drop pipe and foot valve in the canal, drawing water from 1-3’ below dock, depending on tide height. Foot valve is positioned off the bottom of the canal, with total drop pipe length of about 8’ total vertical drop from pump elevation to pipe opening and foot valve. Pump outlet goes into a 1” discharge pvc with a manifold connected to 3 faucets to hook up hoses approximately at the same level as the pump. I will eventually instal permanent in-ground irrigation system, but, for now, I’m dragging 5/8” gardening hoses connected to spike-type impact (Rain Bird) heads.Pump instal was easy. I mounted the pump to a stand attached to my dock, switched motor to 115 v setting, and filled impeller assembly with water. Pump quickly primed and pumped water directly after plugging in the power cord. I did have to adjust the cutout pressure side of the switch to prevent continuous short cycling as pump is apparently shipped with cutout at about 40 psi. Once done, the pump will keep up with the 3 spikes at about 42 psi, according to the installed pressure gauge. I checked the specs on the impact heads, and each is rated at 3.1 gpm @ 45 psi for a total of 9.3 gpm running all three heads. I added a fourth head, but pressure drops to less than 20 psi, and that is too low to make all 4 impact heads cycle properly and throw distance of water also drops significantly. I then checked gpm output of the pump using a 5 gal bucket with no heads attached (that is, I opened all three faucets directly into the bucket, timed fill rate and divided accordingly to produce the gpm). Three separate tests worked out to calculate a gpm rate for the pump at about 10 gpm with full open faucets and about 15-20 psi. Closing the faucets slightly will increase pressures, but drops gpm to about 9 gpm at 40 psi.Bottom line: this is an inexpensive pump that will work for small irrigation projects, but don’t expect it to meet the expectations for gpm published with the pump. Specs list hourly output at 1,200 gals, which converts to 20 gpm assuming 1,200/60 mins = 20 gpm. Truth is , actual gpm is about half of published rate. The pump seems to run fine otherwise and is only moderately loud as pumps go. As I get to the irrigation installation, I will use sprinkler heads suited to “dirty water” with interchangeable nozzles to accommodate reduced gpm of the pump.

Pump as advertised, appears to be well made.Installed the pump and works well.Thanks

Quite and lots of water pressure!

Installation facile, bonne suction et poussée. Je l'utilise pour arroser ma haie de cèdre 2h à tout les jours depuis 3 mois déjà et elle fonctionne très bien! Ma pointe est située 30 pieds plus bas dans un cours d'eau et je n'ai aucune difficulté. Vient avec la pointe et les accessoires pour l'installer en simple ou double tuyau.

Je suis ultra déçu de set pompePompe pas vraimentIl fait un train danfaire dans maisonJe veux avoir un remboursement

So far so good! Better design at all levels, it even comes with cable and plug!It needs a third mounting point/bolt for over the tank installation.