Mothers PowerCone 360, Polishing Tool with Quick Swap Bit (05146)

As a detailer with 15+ years of experience, I have to say this item works exactly as promoted - and does a GREAT job... When you know how to use it CORRECTLY. That being said, here are some tips for those who don't have experience polishing things that don't oscillate: 1. Make sure your surface is clean of dirt and debris. 2. Do not overload the product with polish. Apply a just a few drops, and work the product gently in to prevent it from being flung once you start your drill. 3. Do NOT go full power with your drill. Barely squeeze the trigger and get it spinning at about 1/2 of max speed. 4. Do NOT push the product against the surface with great force. You are polishing, not drilling a hole. Push lightly and allow the product to "deform" or "change shape" slightly while pressing it against the surface to be polished. 5. Do NOT keep it in one spot for a great period of time. That is to say, keep it moving. Since this is for a drill, it will not oscillate and will act like a rotary. If you hold it in one spot, and are applying too much pressure, and going at a high rate of speed, there is a great change you will not only damage the surface of what you are trying to polish, but could burn through any clear and damage the actual rim/item itself. 6. Keep the product moist with polish. If you start to see it leaving little red pieces of debris, you are going too hard and not using enough polish. 7. After you are finished, soak the product in very warm (hot but not boiling) water for about 10 minutes. Afterwards, spray it out and ring/squeeze out excess water and allow to dry. Don't allow polish (or especially compound) to dry inside the product as this will severely degrade it's ability to function correctly. Treat it like a polishing/cutting pad - if you have the experience and get what I'm saying. I just used this to polish all 5 of my gloss blank Enkei rims on my show/daily WRX with ease. Normally, I do them by hand. I decide to use this to save me some time getting in the tight spaces, while also using my Rupes 5" DA on the faces of the 6-spoke Enkei's. Great product and very glad I purchased it. Great quality, great durability, left a perfect shine, and will definitely recommend to others.

Works great really brings out the shine ! Great for getting in tight spots !

Works great! Just the right firmness. Gets between spokes of custom rims wheel. Used on polished aluminum rims and they look like new again!

Don’t wear out your hands trying to polish your rims ! The polishing cone works great, it’s easy to clean, and it’s definitely reusable. You will like this product !

Handy for hard to get spots

Nice tool

Works great. Easy to use around corners. This is my second time getting one because I used my old one so much the foam started coming off and it ended up scratching my wheel a little.

Everything exactly as described. The item arrived on time, well packaged, and in perfect condition. Quality meets expectations and works flawlessly. Very satisfied with the purchase — would definitely buy again.

totally satisfied

Works very well to polish wheels

Tres bien et facile à utiliser

EXCELENTE PRODUCTO

Great cleaning tool has brought up the silver great.