86° Opening Angle Restriction Clip, 2 Packs of 10 Clips, Plastic, Deep Gray, Compatible with Compact BLUMOTION & Compact Clip Hinges

If you have cabinet doors that are likely to hit appliances in your kitchen, these are great option to keep the doors from swinging too far open

These work exactly as designed and are not too restrictive... maybe others reporting they are too restrictive did not install them quite correctly? Mine clicked in just right and restrict my door just shy of 90 ° as expected. I will say, the clips are very tiny, so I had to use my screwdriver to ensure they were lined up just right before opening the hinge to resecure to the casework. What I did: I did only one hinge at a time to ensure the door remained aligned. Starting with the lower hinge, I unscrewed the single center screw going into the casework, leaving the hinge attached to the door. I then closed the hinge so I could access the hole on the back where the clip is inserted. I used my screwdriver to ensure the clip was centered and pushed in as far as it would go, with the curved part of the clip overlying the bar. Opening the hinge with the clip in place seemed to secure the clip into place with a slight click. I reinstalled the hinge using the center screw hole in the casework, then tested to ensure it was still aligned correctly. Lather, rinse, repeat, for the other hinge, and enjoy the success!

I had my kitchen remodeled and several of the cabinet doors were hitting walls, appliances, or other cabinets when they opened. These little clips were easy to install with just a screwdriver and worked perfectly! I can even use my roll-out shelves with the door restricted. (It’s close, but the roll-out doesn’t hit the door.). I’ve attached a photo of one of the cabinets I used a clip on. The left door is restricted and doesn’t hit the wall any more. The right door is unrestricted -no clip.

The angle restriction clips work just as they say. It stops my cabinet doors from opening all the way and hitting the wall, appliances and other cabinets. I was able to use the on cabinet doors with pull out shelves. But if I pull the shelf out all the way past the door, I do have to hold the door open a bit to be able to slide the shelf back in. It's a mild inconvenience since I don't often pull the sliding shelves out all the way. I took off one star to make others aware that these clips don't fully prevent the door from opening up all the way, especially if you swing the door open quickly and with some extra force. For the most part, we are gentle with our doors and if they are opened normally, the clips will stop the door from opening all the way and resting against another cabinet or wall. However, we have two teenage boys who are not quite as gentle on things. If they fling the doors open, the doors will still hit the wall or other cabinet, but the doors will not rest there. They will bounce back to the correct angle and will not be touching the wall or other cabinet. So know there is a little "bounce" in these clips, but overall it's a really great and cheap solution for our problem.

Works perfectly on Blum Compact Hinges. Easy installation.

My cabinets swing open 105 degrees. As a result, when fully opened, they hit the next cabinet over. This causes damage to the opened cabinet by creating a crease (indentation) along the entire height of the cabinet if you open them fast. 1) I posted two pictures. The first picture is with the clip installed on the right cabinet and the default 105 degree on the left cabinet. The second picture is with both installed. You can probably get away with just installing it on one of the hinges per cabinet. I installed them on both hinges per cabinet as I was already installing it, why not spend the extra few minutes doing it on both. 2) Like others have said in the comments section, if you are doing both hinges, don't take the door off. Just do one hinge at a time 3) Also like others have said, no instructions. Just YouTube how to install them. Super easy to install if you know how to place them in the hinge. 4) IMPORTANT: If you are having new cabinets installed, have the cabinet installer install the clips while the cabinets are going up. I didn't know this was going to be a problem for me until after my house was newly built. Now I have to install the clips after the fact. The cabinet installer can do each in 10 seconds while the cabinets go up. 5) They are tiny so if you have huge fingers, you might drop a few installing them

We just redid our cabinets and didn’t want our new hardware hitting our cabinets since we painted them white so I bought these. Unfortunately they are TOO restrictive and the doors didn’t open enough. The actual design and product itself is great and a wonderful idea. Easy to install as well but didn’t work for me. After trying though I had the idea to use small magnets since the brackets are metal. This piece measured 5mm deep so I bought a pack of 6mm x 3mm magnets which worked amazingly well! It’s also easy to install and works no matter your bracket as long as it’s metal. Same process, take off bracket, put magnet in gap, and worked perfectly. I was even able to slip the magnet in some cabinets without taking hardware off. I’ve included pictures of what I did. So if your me looking for a solution because these don’t fit or don’t open enough or maybe still own too much, try out some small magnets. 3mm basically gave me right at 90 degrees which you’ll see in the pictures. The door more closed was this product, the door more open but still not hitting the cabinets was the magnet.

Perfect for my new cabinet job. Easy to install. Works well.

Clips easily inserted into hinges and my cabinet door no longer hits the wall

They do not fit every blumotion hinge, I’m sending them back. For things like this it’s better to buy the component and hinge at the same time from the same stockist. Blum make a similar but different component: 70T3553.

Fits perfectly, now prevents the door from hitting the wall when open

The blum 86 deg. Motion restricker work very well, however I was not impressed on how long it took to send me the product over one month!

Did not fit, so unable to comment.