TotalBoat- Thixo (185ml Cartridge) | Thickened Epoxy Adhesive | for Bonding, Gluing, Sealing and Filling | Use on Wood, Fiberglass, Metals, Brick, Stone, Glass, Tile & More

Easy to use. Managed to fill in several small below waterline screw holes from a transom mounted transducer on my boat. Applied acetone on a rag, got rid of any old 5200 gunk that would interfere with the thickened epoxy, reamed the screwholes, screwed the mixing tip on, laid about a foot of the first mixed epoxy on a cardboard box to prime it, and then began filling the holes. Set in about a day. Great repair. Great product. Came with two tips in case I need to do another hull repair in the future. 10/10 would recommend.

Don’t be fooled. The product is great But it’s only half a tube of product. A little bit of epoxy for a big price

Second time to purchase. Used to fill voids, old screw holes and attach top cap to hull. Does not sag, sandable when dried and easy to use. Only down side is when using a regular caulk gun you really have to apply pressure so it mixes in the tips provided.

This is a pretty good epoxy, but it will not bond to ABS. I was using it to bond a flat, thin, ABS cutting board to the bottom of my RV sink covers. My RV has these hard plastic countertops that have and inner piece of particle board. It's a good, lightweight alternative to solid surface countertops, but at the bottom corner seam, water can get in and swell the inner particle board, which was beginning to happen to the sink covers. I was going to sand the bottom, add the ABS panels, and properly seal the edge. Not only did the ABS panels not stick, but this epoxy also did not stick to the surface of the sink covers. So I went with a thin layer of regular epoxy, attached the ABS panels, trimmed with a router, and sealed the edge with a thin layer of silicone. Looks great now.

Used product 382660 to repair a major crack/ hole in my seadoo gtx. After proper grinding and feathering repair area I applied product not exceeding recommended 1/2” thickness and let cure. Within 24 hours it was rock hard and prepared area for second coat. This time adding a layer of carbon fiber wetting it out with thixo and shaping as needed. Let second application cure for 48 hours then doing the final sanding and shaping. Couldn’t be happier with the final results. I should mention I took a chance on this product over traditional resins because of the claim that it would adhere to damp surfaces. The styrofoam in the hull still had moisture trapped inside and this stuff cured no problem. Thank you thixo! Easy to apply. Didn’t drop or sag. Floats out and shapes like a dream. Wets chop strand or weave as well or better than traditional resins in my opinion. Sanding and shaping was a breeze. Used in temperatures between 55 and 65 degrees.