SuperATVBlack Ops 3500 LB Winch Kit for UTV/ATV | Waterproof Seals and Solenoid | 12 Volt Winch | 1.2 HP Motor | 166:1 Gear Ratio

Heavy duty; fits nicely.

Revised my last review. The ExtreamMax.com grizzly 700 mounting plate, mounts the winch too far forward so the winch terminal interferes with the Yamaha down tube.

Easy to mount and wire up. Sort of a quick connect between contactor and rocker switch, with a single red keyed hot wire to "wire" in.Only used it once so far to pull someone else that got stuck. It worked fine and pulled strong.

Directions were a bit hard to follow. Not too bad for me, but for a novice might be an issue. Was difficult using the viper mount but it was well made. Motor bolts line up perfect but you have to redrill the front guide to fit the front holes.I was able to mount the switch box in the battery accessory compartment which should help it last longer out of the weather. Mounting on the back of the winch bracket was not easy. Front suspension could hit it. I have a 2020 Yamaha kodiak 700.

If you have a little common sense, you can install this winch. I installed this on my 2019 Polaris xp4 1000. I already had the landing bus for the battery neg and positive. Also the accessory wire lead for ignition is also at this point. I used the black ops mounting plate as well. Smooth install. One thing to remember is if Your putting this in a SxS, buy the winch toggle too. The supplied switch will not fit into your dash unless you want to do some cutting. I wouldn’t hesitate to buy again. I’ll post progress as I use the winch. This is based solely on install.