Anodized Aluminum Extended Lever for Ruger 10/22

Took just minutes to easily install. For my rifle, just 3 screws (sling, band, and stock screw) to remove and reinstall and the pin to remove and install the lever. Works like a charm to remove the magazine and is much easier than the stock mechanism.

Installed this the same day it arrived and it only took 20 minutes. Replaced the plastic factory mag release with this extended aluminum release and it looks and works great. I was expecting less for the price and I'm sure there are better options (thicker, heavier) ones on the market...but I am completely satisfied for the amount I paid for it. Works as advertised! Can wait to try it at the range.

Fit and works great

Good fit

As pretty much every review on this lever extender has already stated, this upgrade is a must have. But if you do, recognize you'll get a plastic baggie with label on it and the aluminum hardware. That's it.All you need to do is remove the front screw next to the trigger guard, middle out the safety button so the trigger/bolt hardware can be removed from the stock. The single pin that hols the magazine release takes no pressure to remove - can almost shake it out. Once pin is removed, remove the old mag release and replace with this one, in the same orientation. Slide the pin back in (no hammer needed) and put the trigger/bolt hardware back in the stock, tightening the front screw. Nothing to it.This upgrade greatly simplifies swapping magazines - should have come with it from the factory.

Bends with little use. Should’ve known since it’s cheap aluminum.

Super light weight, perfect fit and installed in under 5 min. It took longer to find my hex set than it did to install this. Excellent finish in what seems to be satin. Does exactly what I need it to and would buy another if I had more 10/22's. Love it.

It goes in but it sits loose like it's not a perfect fit. Feels cheap.