Elevation Lab Magic Grips for Apple Magic Mouse 1 & 2 - [Improves Comfort, widens Grip, Gives You More Control]

I bought these 6 years ago. They’re still attached to my mouse. It’s crazy how the adhesive is still going strong! They make griping the mouse so much more comfortable. I didn’t realize how good they were until I tried using a new Magic Mouse after all these years which didn’t have the grips. Nearly unusable for me without them. So here I am, buying another pair for my new mouse.

This definitely makes it much easier to use Apple's Magic Mouse (1 or 2) for a long time. Feels so much more comfortable in my hand. Pretty easy to apply, I didn't get it perfect on my first try to align in but it came off pretty easily and reapplied very well. I carry my mouse in a case so that it doesn't get scratched in my bad and it still fit in there since these don't add much bulk to it. The material feels very high quality and doesn't ruin the look of the mouse as it may not be the most ergonomic but it's very nice looking and but adding these on there you can get both. I didn't want to stop using my Magic Mouse because I love how well it works with MacOS for switching desktops and scrolling but it wasn't comfortable. Luckily this gets rid of that issue. Haven't seen any other products that do the same so not much to compare it to. Overall this is not going to completely change the feel of the mouse but it is a pretty big improvement.

I have both Elevation Lab's black grips and this meatanty's. Elevation labs has better shaped surface with slimmer contours which helps to lift up the mouse easier, while Meatanty adds thickness to sides which is better for bigger hands. After a certain time 3M sticky surface loses its adhesive on both brands and starts to peel away from edges, especially on Meatanty as seen on the photo.Elevation labs has better adhesion on corners but the bottom section of it is a bit thick and adds extra friction on some surfaces like mouse pad and effect the glide of mouse. Meatanty's matches better with my white mouse while Elevation Labs goes well with the black mouse.Upper edge of the grip sticks out of from the top surface of the mouse, and my thumb usually rests on that edge. Few days later sticks are not holding it as they used to be so I push them up to get adhesive surface reattach to the mouse firmly again.I guess it's an issue of design yet still the added comfort can't be matched! I recommend getting these if you have sore finger tips cause of Magic Mouse design.

This is a super idea. It works great easy to use. Fast shipping works just right 3-M tape sticks like nobody’s business. My large hands love the Magic Mouse now

This is my second set. The first lasted 8 years. These make using an Apple mouse very comfortable ergonomically.

Due to how I grip my mice (non magic) I find the Apple Magic mouse unusable due to its sharp edges and low profile. These grips make the Apple Magic Mouse (I have v3 and they fit fine) usable. I am not sure how they will last long term but at least I can get a comfortable grip.

I've been using these for the past few months and it's helped tremendously with my wrist pain. It's just a better grip on my mouse and I have only had a small issue with it in the time I've had it. One of the sides moved slightly, but after removing it and cleaning it with a little bit of isopropyl alcohol it was good as new.

First off, I am what you would call a "claw gripper". While it does allow for a better grip, and make it easier to control, its been just over 2 months, and the rubber is exhibiting a permanent depression where my thumb normally rests. I would expect it to last much longer than two months.For the people having issues with the adhesive tape not sticking, clean the sides of the mouse with rubbing alcohol (removes the oils from skin contact that would prevent good adhesive bonding), and then lightly heat the adhesive surface with a heat gun or hair dryer (just a slight amount to get the adhesive tape to be "tacky"), then attach to the mouse.