OliYin 10pairs JST-XH 2.54mm 1S 2 Pin Balance Plug Lead Socket Male and Female Connector with 22awg 10cm Silicone Wire Cables

Grabbed these to add two fans and extend the length of another. Nicely pre-tinned and has some good quality silicone.

Exactly what I needed to build my speaker based on the Satellite 1 dev kit from Future Proof Homes.

I am using one of these to wire up a relay for an Arduino board to switch a 120 v water pump on and off. The connector works as advertised.

I used this instead of buying the ComfortBilt Pellet Stove thermostat connection wire. In order for this feature to work, your stove must already have the blue 4-wire data cable style electronics. (Cycle through your modes to see if your panel has the 'Thstat' mode available). Follow the manufactures instructions.

I have a Dry Guy Turbo boot dryer that uses a small fan motors in the fan units to dry out my work boots. The bearings inside the fan motors in the dryer housings wear out and need to be replaced periodically. I am using these connectors on the power wires for the fan motors to enable me to quickly and easily swap out a failed fan motor. They are nice and small and will easily fit inside the Turbo dryer housing. They look to be of good quality and they should last me for a long time.