Creality Official Ender 3 Extruder Upgrade Metal Drive Feeder 3D Printer Parts for Ender-3 Pro/3S/3 V2/3 Max CR-10/10S Gray Aluminum 1.75mm Filament Extruder

The product works perfectly well, though it is a little difficult to put together as the instructions were more like following a diagram. But overall, I am very impressed with this product.

I had been having trouble with the filament slipping in the original Creality plastic extruded. This stopped all of that. Great product.

I installed a metal extruder on my Ender 3 Pro to replace the stock plastic one, and it’s been a great upgrade. The installation was easy — it bolted right up using the original hardware, and the filament path lined up perfectly without needing any modifications. The metal design feels way stronger and more durable than the stock plastic extruder. With the old plastic one, I had issues with the arm wearing out and slipping over time. Since upgrading to metal, extrusion has been much more consistent, and I haven't had any problems with skipping or under-extruding. The tension adjustment is smooth and firm, and it holds filament securely without grinding it down. It’s a simple, affordable upgrade that just makes the whole system more reliable. If you're still using the original plastic extruder, I definitely recommend swapping to a metal one — it’s an easy fix that makes a big difference over time.

The product was very easy to install, and it function flawless. And I plan to order another one and the near future.

Great quality. My only gripe is that the first time i bought two and one of the two bags contained ONLY the base metal plate and none of the other hardware. Replacement was sent out but now I have to go through the fun of returning the old one. Not to happy about the wasted time there. Both are installed now and the process was very easy. Very high quality. Definitely a worthwhile upgrade.

Great upgrade for my Ender 3. Even at the lightest setting it was squishing my filament I just had to adjust the spring and then it's working perfectly.

Most of these 3D printers are copies of the commercial ones and pretty generic. I took one look at it and knew it would fit, as it's aligned on the drive axis of the stepper motor (like 99% of them). My bowden mount on my Aurora A5S failed and broke. What can I say? it's plastic and Aurora does not sell the part that broke! I like the tension adjustment on this one, no more sore thumb, and less dust. It has a firm grip on the tube now, and I'm back in business! The instructions could would be better if they were steps. There's definitely an order to putting it on. I tried putting it together on my desk, had to take it apart again! Install the lever last.

Massive improvement over the plastic one that came with the printer. Plastic had somehow worn a cut into the plastic one, but this has no such issue.

Jala genial se lo recomiendo mucho este producto ya lleva dos día activo y ya no se atora

Adequada e de ótima qualidade e resistência.

Easy to install and great quality

Much more reliable than a plastic extruder and super easy to install if you follow the video on this page. I didn't even need to replace the press-fit gear since it was still in good condition. Overall, it was a very low effort, high impact upgrade for my aging Ender 3

Yes this made a difference over the stock plastic one. No more separation layers! Installed in only few minutes on my Creality Ender 3 Pro. which has a 15mm motor shaft- no issue. Remember to redo your e-steps and flow calibration after replacement.