TURBO 9 x 33 Inch Skateboard Grip Tape Sheet Black

Good grip, great adhesion...not much more to say...it does it's job.

Just what I needed. I was not using this for a skateboard. I wanted to make a kick plate on my RV door. The previous owner just used foil tape that looked ugly. I used only the adhesive that was on the grip tape. and it is holding up very well considering it is subjected to wind at highway speeds.

Holds up, was the right size. No complaints here.

I needed this to wrap around the exterior of Kydex holster for better retention while used as a pocket holster. The surface has excellent “grabbiness” and the peel-and-stick tape conforms well to curves of the holster. This tape sticks TIGHT! It won’t be coming off very easily!

Used to recover the step treads to my RV. Much better than the original.Ordering a pair for the step wells on my van as well!

Really can’t complain about grip tape. It’s sandpaper on one side and sticky snot on the other side. Rate 10 out of 10

I bought this to wrap my Tri bike handlebars, since I tend to sweat a lot and it makes it easier to clean. It seemed to grip fine, but the texture wore off fairly quickly just from sweat from my hands over time. After a couple of months the grit surface would be gone (literally the little beads of grit would wear and fall off) and then I’d have to remove the tape and apply a new piece. Usually had to do this 2-3x a year. That being said, when you remove the tape there is very little residue, so it make cleaning and reapplication easier.

Good material and easy to install on your skate deck