Flutesan 6 Packs Dusk to Dawn Sensor for Outdoor Lighting 100-277V Photoelectric Switch Photocell Light Sensor for Most Outdoor Lighting Fixtures

3 of the 6 order do not work. Attempted to repair light pole with items. Looks and fits good however does not operate as described. Waste of money. Did not need to use item until after return date had passed so I have six pieces of trash to dispose of.

Worked perfectly for my application, liked the fact there was very little gap where the wires went into the photoswitch body to jelp eliminate the possibility of foreign object contamination, fairly good value for the money in my opinion.

Bought a box put one in worked for about 1 year then went out. Went to put another one in and out of the 5 left not one of them worked. Thought it was my wiring. Went over it several times and tried all kinds of different things they all turned out bad. Would not buy again. Waste of money.

A great dusk to dawn switch with a quirk. First, note the size of the switch. It is a bit large to fit in most fixtures, so if you are hoping to mount it in the lamp fixture, that may be a deal breaker. I mounted one of these in a cover plate, and I mounted another next to a lamp fixture where it is not obtrusive. But I was fortunate to have such locations. I have other switches that I'd like to use, but I need to think of where I can mount them. The quirk is, after you power the switch up, there is a 20-30 minute delay before the switch closes, even if it is dark. So if you wire this up and want to test it, you have to figure in the 30 minute delay. It also means that if you wire it after the light switch, that there will be a 20-30 minute delay for the light to come on after you throw the switch. So I wired mine before the switch. Now if I turn the switch on when it's dark, it turns right on. You need to drill about an 11/16 inch diameter hole to mount the sensor, and it needs to either be inside an approved fixture or an approved utility box. Fortunately I had a couple of utility boxes and some Romex in my junk drawer so it was relatively easy to mount these sensor/switches remotely. I have a large property at the edge of the city and I have a lot of outside lights and a lot of solar power and the need for security, so I am wiring up almost all of my lights for dawn to dusk.

Low cost but you get what you pay for. 1 did not work out of box. Rest were good so guess 16% failure is fine.

Excelente

Tested 4x each. One dead, one seemed erratic, would work then not, work, not. 1 of 5 tested quick on/off about 10 seconds or less. Other 4 about 30 seconds to switch on and off. So with 33% possible failure rate, over priced. 20% for sure failure rate.

The first one worked for me. I’ll test the other 5 soon. To avoid flickering when the sun goes behind the clouds and during dusk, pretty much every photo cell these days has a 1-3 minute delay. So, after you install, you have to cover the photocell for 1-3 minutes to test it. That’s probably why people report them as broken; they only cover the photo cell for 15-30 seconds. That’s not enough. Do it for 10 minutes before you decide it’s broken. They are brand new and are just standard photo cells but at a great price. No reason that they won’t work.

Buen producto

Muy practico para adaptar control de iluminación en zonas patio y fachadas Ahora tengo luz de noche en mi cochera y jardín si tener que preocuparme por encender y apagar luces, con un solo sensor puedo automatizar todas las luces de mi jardin

Quisiera comunicarme con la empresa porque ninguna fotocelda funcionó, tenía el propósito de instalarlas en unas lámparas nuevas pero lamentablemente ahora que tuve tiempo para hacerlo estas no funcionaron..

Únicamente los instalé, que fué muy fácil y su operación es perfecta.

Es mas grande de lo que esperaba.