Detroit Axle - 2 Front Wheel Bearing Hubs for Jeep 2007-2010 Wrangler [4-Wheel ABS], Replacement 2008 2009 Wrangler Wheel Bearing and Hubs Assembly Set

Replaced both sides on 2014 Jk, fit was perfect and seems like quality part, no problems on the first 1000 miles and the price was low. As others stated, the sensor cables are shorter then stock. Had to reroute to reach connector, but they still work with 2 inch lift. A good purchase.

Well so far they are good we'll see how long they last

Parts were delivered early, were a perfect fit, and easy to install. The speed sensor wires could be a little longer. We will see how long they last but for the price, I'm happy with the purchase.

The parts fit as described and seem to be good quality. I would recommend this product to anyone needing to replace both hub assembies/wheel bearings.

ABS Sensors did not match up to old sensors. Wires are shorter and does not lock in place where they are supposed to secure on the original brackets. I’d say you can zip tie them down in one section but their so much shorter finding a good location to zip it down is very difficult because of the length. I can see these being ripped off at some point while on the trails or just from snow.UPDATE: Messaged the seller about fixing the issue and they offered me a $10 refund for me to buy new sensors that cost $25 each at the store before tax. Many messages later they offered to pay for one and that’s bad business in my book. If you sell something that’s incorrect then you should make it right. Send the correct sensors or pay for the correct ones. I’m ripping these off my Jeep and sending them back. I’d stay right away from buying these. The sensors are way too short and the seller knows it but won’t remove the listing or correct it.