RSATAB LED Closet Lights 90 LED Under Cabinet Lights 2600mAh Motion Sensor Lighting with Remote Control,Rechargeable Wireless Kitchen Night Lights,Battery Powered Light for Cabinet,Wardrobe (3 Pack)

I was pleasantly surprised when I received them and found that they have a USB-C charging board.I got a three set for 29 dollar and it came with three lights, three charging cables and one remote.We do t need the remote it I checked and it works.The lights are bright and I dimmed them down for the use in our closets. Otherwise too much light.I can’t speak to the quality yet and it seems that some reviewers had not much luck with the quality.I will decently update the review (as always) should one fail prematurely.As long as the original review is up the lights work as expected.They also came with a extra set of metal plates with a sticker attached so they can be easily mounted.The plates also have a hole so one could use a screw to Lou t it.The light itself is magnetic and can just pulled off to be charged.So far I would buy them again just because the brightness and the USB-C charging port.

Three specialized C cords and standard USB otherside comes with these three lights. So each has one. Do not lose if you have mostly micro end cords as we do at our three charge stations about home. You'll want to keep maybe one or two handy to recharge these when needed. HOWEVER for our needs I am putting these on underside of an upper cabinet and attaching with super strength velcro smaller light weight power banks that one bank has two ports to will power both these lights an keep recharged. So won't need to unplug often and because beneath that cabinet on the counter below is one of our most used charging stations I can also run a lead to the power banks with a six foot charge cord I have allowing me to rarely need to pull down the power bank and disconnect from these lights. Of course I will need two powerbanks as both of the small ones only have two USB out going ports and if you are putting up three lights I'll need two. But this method would allow you to do the same in any location including three different ones if need be. It'll provide less wear and tear so to speak to the ports too and plugs both. Ok these have decent sensitivity. All charged up pretty fast. Only one lagged a bit behind the other two but soon were all charged and ready to install. If you choose to use the adhesive backed metal strips by all means clean the area properly. For us it'll be a formica contact so easy to do and no damage will happen when or if it's removed. Caution is needed if you want to attach to any painted surface. ANY PAINTED surface people has a potential of failure and damage including faux wood veneers or even cheap wood veneers too. Paper veneers also can fail. Wall board or plaster boards painted can fail or be damaged if you need to pull off the adhesive or the adhesive fails to hold due to the pain layers being too weak to hold the lights weight. So ceramic, marble, or smooth natural stones that have been polished, formica type veneers all should work great as would of course glass. But always clean well what ever surface you intend to stick the adhesive to. And that means first soap and water and rinse well and dry for 24 hours at least. If need be straight cleaning alcohol no hand sanitizer or massage alcohol products with skin softening additives etc. Just straight 72-97 proof alcohol from your pharmacy. Do not use any other cleaner such as a spray on product as often they too leave behind residues or additives that can cause the adhesive to fail. So SOAP, Plain water rinse, alcohol or not to remove any possible past imbedded residue. To remove the adhesive try warming with hair dryer and carefully pulling off. The 3M makes a kind of adhesive you pull the tab on to remove later on that works pretty well. I never used on papered walls or veneered walls but have used on real wood paneling and formica and metal and ceramic tile all with good results with no damage so if that's a concern maybe look into that to substitute this adhesive with. You can also screw the metal plate onto the wall or cabinet but that's not always easy to manage. The lights themselves are all three good. One remote for all three. So keep that in mind where you place them and how easy you may need to reach or use the remote if at all.

I bought 2 sets of these lights 6 total. They worked well right out of the box. Motion detection works well. Loved the lights. First time I charged one of the lights it never worked properly again. The sensor nor the remote would activate the light. I contacted Amazon and the are sending a replacement set. Last night I charged the remaining 5 lights. One of the does not work at all after the charge. I don’t know if both bad lights are from the same set, which may have been a bad batch. So I’m down to 4 out of 6 lights in a matter of a few days. I don’t know if I would buy these again. I’ll see how the replacement set works. Not happy at all.

Sometimes I want light as I walk about at night but don't have a need to turn on the house lights so I decided on mountable LED lights and I's super happy with my choice. These did just the trick, I use them at night and they provide enough light to ensure I clearly see but not so much that it hurts my eyes when going from a completely dark space to a lit space.I have no feedback on the motion sensor function because I don't use that feature, I stick to using the remote which I find easy to use and functional for my specific needs.

Used on the ceiling of my computer nook as it had no original lighting. This product in my opinion is superb. The quality seems to be really really good, and the action and light is fantastic. My only disappointment was that the instructions are written in what some might consider English, but somewhat Lacking and getting the point across. After some playing with the product, I was able to figure them out, and they work well, do exactly as they were advertised, and in my opinion are very good value.

Nice lights - bright, good functionality, easy to use. One complaint is the adhesive application. After 3 weeks of installation in my closet, one of them fell down because the adhesive completely detached itself from the metal plates. Another two weeks later, the other one did the same. What was suppose to be easy install has morphed into something more complicated where I have to screw them into the wall if I want to continue using them mounted. So don’t count on the easy installation.

I got the three pack for my back hallway, I live on the second floor. They work great !!!! I came back for a second set to always have a replacement when they need charging !!!! Bonus, they were on sale 20% off when I came back to repurchase. Thank you !!

The lights are bright and the remote is a convenient feature IF the lights would actually stay without crashing on the counter due to the horrible adhesive/tape. Returning them today