BlingKingdom 5 Sets USB Type A 4 Pin Male Jack Connector Adapter Plug Socket Connector Solder Welding Plate for DIY USB Power Supply Breadboard

porduct works great, for larger cables you can file the hole out a little bigger on each side until it fits snugi included a picture of the pinout

worked perfectly

Good replacement. Only issue is the part that the wire covers, is not a good fit for most wires. So I have to carve it out a bit to fit. It runs small. Still a bit of a gap. But I just use shrink wrap to secure it.

I used these to repair a surveillance camera and automated cat feeder. Both of their cords were chewed on by my young cat. Anyone with some basic soldering skills can get these to work. Once the wires were soldered into place, the two halves snap together and you're good to go.

These work GREAT~!Since MOST of the LED fairy lights only have lead-ins that are less than 16", these let me custom make my own.

Purchased this for my thrustmaster tmx racing wheel instead of buying the usb a dongle as they tend to fail and not work. Just cut the end, peeled the wires and solder. Had to drill out the cable hole as it was a bit to small. Then filled the empty space in the casing with e6000. Worked like a charm.

Could of had wiring diagram

I don't know what of the guidelines I failed