280PCS M2.5 Female-Female Nylon Hex Spacers Standoffs Screws Nuts Assorted Kit(Black)

Most of the standoffs were great, but there were two sets.. the 10mm and 12mm pieces, each and every single one had not been drilled/tapped through completely, so one side of each standoff was completely unusable without some manual work. (No, just "screwing through the plastic with a screw" didn't work)Go figure, those were the two sizes I needed for the job at hand and I just had to make due. Not super thrilled, but also not worth the hassle of going through a return. Will be looking for a better quality kit in the future.

I am working with some Orange Pi devices, in particular the NAS expansion board.Then, when you add a mSATA storage device to this board, it needs some screws and the Nylon ones are perfect for the job. Right size, very delicate construction and overall device protection.Oh yes ... these are M2.5 (for Raspberry Pi), but they work well on M3 holes as the ones the Orange Pi has. So, I won't worry having a lot of different parts when the M2.5 do a good job. Also, these parts work well as no metal separators when that is needed (there are many opportunities to require that).I will purchase more later.

These are great for mounting microprocessor boards like Arduino and Pi in that you don't have to worry about any shorts like you do when using metal hardware. A really great selection of sizes of spacers and screws. I'm going to stock up on more of these kits because you just can't have too much mounting hardware on your workbench.

I bought this product to cover the short comings of the Acer Corporation who I bought a laptop from. As far as I can tell the E15 E5-575-33BM is a great laptop unti tou wish to install a M2 SSD drive in it. Acer did not provide a mounting screw or standoff with the computer. So save yourself the trouble and buy this set of M2 screws and standoffs. Use the shortest standoff and your SSD drive will mount fine. GREAT PRODUCT AND A LIFESAVER!!!!

If you use these to attached the top and bottom plates of a quad and you crash, the bolt heads will pop off. Even a light crash it will happen. These are not durable items. They will work well for attaching a pdb or FC to the body.

good as expected

A must for building custom micro drones.

Product is as advertised and does a good job. I would buy these again.