SMALLRIG Extended Arca-Type Quick Release Plate for DJI RS 2 and RSC 2 Gimbal - 3162

Really great little must have for any RS2 owners, because otherwise fine-tuning roll balance is finicky (all the weight is on the arm, and it gets very stiction-y). This plate also allows you to move the center of mass even further out than the furthest point the RS2 arm would allow, saving you the need to use counterweights, and thus removing the added stress on your motors that counterweights would create. I would also note that the plate that comes with the RS2 is not adequate for larger cameras, like a Red Epic. It's just too small. This works like a charm, giving you a much larger contact base, and two or even potentially 4 screw in contact points. Sturdy and easy to use. Also works great as an standard Arca plate. We also bought a slew of SmallRig Arca clamps (I recommend the ones with the stainless lever on the side, as it has a more complex cheeseplate at the bottom more likely to fit various mounting options, and the clamping mechanism does not protrude above or below its height, so it works fine even sandwiched between two larger objects.) With a slew of the SmallRig clamps and theses plates, we can snap on and off cameras to our RS2, our sliders, dollies, tripods, jibs... etc in a few seconds. No more wasting expensive set time fiddling with screws while actors and rented locations stand idly by. I know the whole collection it will pay for itself in one set day, max 2. All in all, I'm really glad I found out about these. (We bought, I think, 8 in all).

Extremely happy.. Managed to balance my c80 perfectly, and saves me spashing out £1000 on the new rs4 pro to accomodate the extra bulk that the camera has. .. Very well made, as with all SmallRig coming out at the moment.

This plate fits just as well as the stock ronin RS3 pro plate from DJI. It is more adjustable side to side for balancing heavier or larger rigs. It is much more secure when using it with my Canon C70, the double 1/4-20 screws for the plate line up perfectly in the dual 1/4-20 mounts on the bottom of the C70. By using both, it is way way more secure than the single from the original stock DJI plate. I’m glad DJI was out of stock and forced me to buy this one to replace my original, it’s a much higher quality upgrade, and compatibility with the RS3 pro is perfect. It does not add any noticeable bulk or weight, it actually feels much more solid without noticeable taking up any more space. I plan to buy another one to keep on my other camera as well.

All OK!

La compre para RED komodo X y va fdenomenal con mi gimbal RS2