Treedix 2pcs JTAG Breakout Board Adapter Converter SWD Breakout Jtag Debug Board with 2 Row 1.27mm Pitch 10pins Female to Female IDC Connector Flat Flexible Gray Ribbon Jumper Cable 200mm for J-Link | Jtag Debug Board Female to Female IDC Connector Flat Flexible Gray Ribbon Jumper Cable 200mm for J-Link

Used this in Lattice FPGA project; connector is nice and small

Very good quality,fit is tight and PCB is clean.I will recommend highly 😁👌

This apparently only comes with wires but the listing explicitly says it's a breakout board with wires. I first thought this was a mistake but when the replacement came I saw that there is still no breakout board. The wire is useless to me without the breakout board.

I used this breakout board adapter to connect to a J-Link EDU Mini.

These were a good, cheap alternative to the overpriced ones on DigiKey. However, the end connectors may have been attached wrong. The wrong signals were going from the programmer to the jtag adapter on my pcb. There’s a notch on the connectors on each side of the cable, so there’s only one way to connect them. I had to cut off the notch on the connector of this cable and rotate it 180 degrees before plugging it into the programmer. That was the only way they worked. Other than that, I’ve had no issues with them.

I needed these for connecting JTAG to my projects. Works great.Pin labels are correct. Pin labels aren't quite the names I expected/use, but easy to figure out.

Nice board but their quality control is poor. I spent a decent amount of time trying to figure out why my debug setup wasn't working. Eventually, I looked at the solder joints for the surface mount connect under a microscope and I saw the solder past wasn't melted. I had to carefully hit each pin with the tip of my solder iron to get it to flow. The picture attached is after I made the correction. Make sure you have some rework tools if you buy these and at a min do a continuity test on each pin before using it.

I am using this with a Segger EDU J-Link. Used the attached image for the connections and it is working as expected. Connected to a Nordic Semi nRF51822.

It’s expected and useful for my work. But it comes it to to parts join to gather i am not that expert so i broke one part but other one still working except and also it not comes with the lags so you need to buy it extra.and do the sholdering.

Two boards included, solid build, very handy for development.

The package only contained two cables. There was no breakout board. The product description is wrong.