T T-ABC Mods Tail Lights for Toyota FJ cruiser 2006-2020 LED Taillights Assembly Modified Lamp (SMOKE)

Look awesome and once you figure out what to do it’s a pretty easy plug n play install, but for three hundred bucks you’d think they’d provide some decent instructions. Makes things a lot easier on yourself if you remove the entire lower side panel. Take the rubber flooring up first as there’s two screws under the flooring that hold the side panels down. You need to remove and reuse the entire wire harness from the old tail lights including the bulb sockets. The new connectors plug into the bulb sockets of the existing harness. There’s a right way and a wrong way to plug the connectors in. How to know which is the right way is beyond me, but you have a 50/50 chance of getting it right the first time. If you plug them in and they don’t work, disconnect and turn them around and plug them back in and they will work.

These look outstanding. The directions are not complete to successfully install thanks to buyer reviews here I was able to make it through the process

The lights look great. The wiring diagram and connectors are incorrectly placed for American models. On the diagram provided, what is described as the brake light is actually the wire to the turn signal and vice versa. The other wires are correct. With a lot of diagnostic testing and few new splices, I was able to get them working properly. Also the connectors provided do not fit the correct harness to make the lights work properly. Just forewarning for anyone who is going to buy them, you will have to put in a little extra work.

Looks great and updated my sons 2010 FJ Cruiser to look like a newer model. Easy to install and took less than 45 minutes with Google How to Replace video.

These are not wired for 2012-2014 FJs. The turn signal is in the clear circle (stock). I spent a few hours just trying to get one of them to work, no luck. Not plug & play. I could have rewired them to work.

Great upgrade compared to oem. Leds are bright and install was fairly easy. I was finished in an hour.

This is ALMOST plug and play. There are three connections that have to be made. 1. Turn Signal 2. Reverse light 3. Rear main light/brake light The set that I received had adaptors for #2 and #3 that were simple plug and play adaptors. The turn signal however only had a bare red wire dangling from the housing. After the 45 minute process of removing my subwoofer and trim panels to get access to the housings for removal I wasn't going to be denied in getting the install done. I used some intelligent thought to splice the bare red wire into the existing turn signal wire and VOILA! I was good to go. I made sure to test everything before I put it all back together and found that I had to rotate one of the reverse light adaptors so it would connect correctly. All in all I am PLEASED with the outcome, but the manufacturer did a HORRIBLE job of making it plug and play, which is ashamed because it was VERY CLOSE to being plug and play, just one more adaptor that needed to be included. Luckily for me the splice was simple (because I've done it before and had the tools needed). I could see how a complete novice to this type of work would be extremely frustrated with this assembly.

Product itself is great. They are plug and play but a little difficult to install because of FJ's design. Totally worth it though!

Looks awesome hardest pard was getting access the the original bolts. Works fantastic!!!!

Me gusta mucho como se ven en la camioneta