Traxxas 6893X Blue-Anodized Aluminum Bearing Adapter (with bearing)

See pics for comparison and exploded slipper clutch view. I did this to my slipper clutch on my 3500 brushless modified Stampede 4x4. Original is plastic and weak. This really doesnt weigh any more to speak of but is a much better part. I mention wright because the lighter your rotating assembly, the less wasted power, you can take it from there.I did take the opportunity to install a few more of my Fast Eddy ceramic bearings while i was in there. Also, highly recommended. I just saved all me new besrings and take-offs for "emergency" scenarios.Conical end of thrust bearing adapter fits perfectly on the inner besring race and will not flatten out under the spring load, which would ultimatley eat the bearing. Good part, increase reliability for a few bucks.

Prevents slipper clutch slop and eliminates the possibility of the stock plastic one from breaking. Must have for slip clutch eliminator setups!

This is definitely a worthwhile upgrade!

Definitely needed if running a 4x4 slash though i didnt but fried the plastic one in 1 week twice!! Then fried the bearing! Bought this and fit great as should its from traxxas and hopefully holds up better!!

Worked great

Good spare to have in the tool box. Sucks when you blow this bearing during as race night. Traxxas quality just remember to oil every 5 to 6 runs.

Anyone with a traxxas slash 4x4 should switch to this setup. It replaces the plastic cone that runs against the bearing for the slipper clutch. If you're tired of readjusting the cone is because the plastic ones get worn and get pushed into the bearing on the slipper clutch.Once this is installed no more readjustment your takeoffs are more consistent and you just install it and just have fun.

Very good over the plastic stock adapter but overtime it was still get damaged, but definitely not as fast as the plastic I’ve used for over a year snd barely gave up