Corvette Jack Pucks Billet Aluminum Lifting Puck, Red, 4 Pack | Anodized Corvette Jack Pad, Floor Jack Pad, Compatible with 1997-2025 Corvette C5 C6 C7 C8 & Most Porsche Models

Excellent product! Installed on my 2021 C8 Corvette in 10 minutes! I originally purchased the pucks that had only one bolt and found it almost impossible to align it correctly. These have 2 bolts so holds orientation perfectly.

Easy to install and they work great. Great value and they match my car.

Install was tricky, but worked perfectly. Amazing product

Great fit on my car. Very obvious where to lift it. Installation was easy and quick. Highly recommended.

Good product, fits, works, correctly sized and well finished with all hardware. Pre-assemble them most of the way leaving about a quarter inch gap, add threadlock, feed them in, twist in place, and finish tightening. They add just enough height to allow a flat surface to clear the body, and make the correct jacking points obvious. Great. The threadlock may not be necessary but the bolts are small, there’s no room in the joint for bolt stretch, and there is no way to add lock washers with the recessed cap screws. So I suggest it if you intend to leave them installed, which is one of the main benefits, then use threadlock. About the only thing I can add is that I’d like the jacking surface to be hatched but it would add a lot of cost to making them and maybe not add much real benefit. All in all very happy with the function and value.

These should work fine. I've not tested them. The milling is rough, but these fit my 22 Vette just fine.

One of the first so called “mods” done to my Vette. Purchased a used Vette and you could see where previous people jacked up the car incorrectly and cracked the fiberglass. I installed these units so that anyone who looks under the vehicle knows exactly where the lift points are. Easy to install and comes with tool needed to tighten it up. My tip would be to assemble it somewhat on the bench so that the screws are flush with the edge of the block. The. You can install it in the slot and turn it 90 degrees before starting to tighten. Tip #2, if you have a battery powered ratchet, use it as the screws are a long and using the Allen wrench can get tiresome fast. They do not hang too much lower than the car so I haven’t had any issues with them scraping anything including the wide neighborhood speed bumps.

Easy to install and work great! I used blue locktite on the bolt threads to make sure they don't come loose. Well worth the money. I would buy again. Installed on 2016 corvette.

All fitted well

They were sent scratched ….

Well made fit easily

All the bolts were missing and all the small backing plates were missing.