JONSBO CR1400 RGB CPU Air Cooler, 92mm PWM CPU Cooler with 4 Heat Pipes, Removable Computer PC Fans Easy to Install, Quiet Rainbow RGB Cooling Fan for Intel LGA 1851/1700/1200/115X, AMD AM4 AM5, Black

It cools - I put this into a RGB monstrosity, and it fit right in and was cheap so more RGB went into it. Performance is that it works as good as an OEM cooler so I guess that is acceptable. Nothing over the top at all but I was looking for this level and RGB was there - I would probably grabbed the addressable version if I did it again.

Amazing for the price! With my 5700G in my Thermaltake V1 ITX Case. I get on averge 37 degrees celcius on idle and using most "Stress Testing and Benchmark Apps" I got an average maximum of around 70 degrees celcius. AIDA64 Extreme for almost an hour I hit MAX 71 degrees celcius. Prime 95 Torture Test maxed out at 73 degrees celcius after running for about an hour too. Pretty good for an ITX Case! Average "room temperature" was 26 degrees celcius. CPU on default settings, no overclocking. This is using IC Diamond 7 Carat Thermal paste, using the 3 line method of applying thermal paste on my 5700G, then placing the cooler on top. My ITX PC build runs fast and cool with this extremely good looking, great build quality and very reasonably priced CPU Air Cooler and I would highly recommend this product for a budget and/or Pro PC Builder.

Installed on an i5-11400, temperatures always below 70°, an excellent option if you don't want to spend a lot on good air cooling.

This is a nice fan, very quiet, works well. I had to use it to replace a previous fan that just would stop fanning after a while. That being said the mounting screws on this might now fit your board(?) they did not fit mine, and so I had to remove the screws that came with it, and then cut the springs down, and use the mounting screws I had with the other one. Its working great though, so just beaware of the size of screws you need, because I wasn't the ones that came with it were too narrow for my mounted holes.

No software is required to use with this CPU cooler to get the rgb lights on it working, which preferably is how I like my pc components since the more software reliance then the more chances of failure. Keeps computer temps moderately low and looks nice. The fans are silent in my use case since I have it inside of an old Dell office computer, however even with the side panel off it's still moderately quiet.

La verdad no recuerdo cuando compre esto pero aun lo sigo usando y me parecen muy buena opcion para equipos pequeños y de bajo consumo

Only complaint I have is that the fan brakets are a little hard to get on and off, and that the rear facing screws are a bit blocked by the fins. Other than that it is relatively quite, rgb is bright and not too fast-paced and thermals seem to be ok in my setup. Seems to be a good cooler specially in this size range(<136mm) NOTE: THIS IS NOT ARGB IT IS ONLY RGB

【CPU＆Socket Support】Intel: LGA1700/1200/775/1150/1151/1155/1156. AMD: AM4/AM3+/AM3/AM2+/AM2/FM2+/FM2/FM1. THIS IS A LIE!! It DOES NOT fit Socket 775. It could have, if they had made the slots in the bracket just a little bit narrower. I may try fixing that sometime later. Still, it's (supposedly) rated up to 136 watts, and it looks nice. It also looks like it might fit in my Thermaltake V2 case (which is a small case for a tower cooler). I got it for $19.99, so I'll find something to do with it. I'll give it a proper review when I get a chance to actually try it.

Exelente funcionamiento sigue trabajando al 100

This was a super easy install. I have yet to switch to liquid cool, so this fan and heatsink work well for my ROG Strix. AMD already has the bracket installed so it's a no brainer. Unfortunately you can't control the RGB but it still looks pretty sweet.

Está weno, cumple lo que ofrece, las lucecitas no me interesan, además es mejor que lo que tenía que ya estaba en las últimas. A menos que explote, o algo así, no le veo ningún problema.

Perfect all I can say!

good better than stock cooler