2 x 2.4GHz 6dBi Indoor Omni-Directional WiFi Antenna | 802.11n/b/g RP-SMA Female Connector + 2 x 20cm/8" U.FL/IPEX to RP-SMA Pigtail Antenna WiFi Cable

Good buy, durable quality, works fine

Good antennas. All mounting hardware came with them. I use these on microcontrollers.

I purchased these as an emergency replacement for the antenna that comes with an ASIAIR Plus. The performance was much poorer than the original supplied antenna, but somewhat better than no antenna at all. At this price I'll keep them around and hope an emergency doesn't occur. I'm rating this 4 star because I don't know if the antenna is even supposed to be appropriate for my device, perhaps it would be fine with other devices.

Using this on an ESP32 connected to pool equipment outdoors in a cabinet. Since I started using this antenna the wifi signal has been spectacular.

I bought these for an ESP32 boards that support these antennas. Great range, very sturdy, and solid materials. Happy for the locking washers. I'm getting a great signal from 10ft, through an exterior wall. The cable length from the antenna to the board is perfect. Other than that, it looks great. I'll definitely be buying these again in the future.

Perfect replacement for my iAquaLink outdoor system. Just be careful removing the old one from the mother board and also installing the new one. Use needle nose pliers. Gently.

As some other reviews have indicated, my Jandy iAquaLink 2.0 WiFi antenna deteriorated with the sun and weather and although I taped it up to make it last, I finally needed to find a replacement. Again, as others have indicated, a new Jandy iAquaLink 2.0 or Jandy iAquaLink 3.0 total unit replacement was ~$500.00. Following the advice of a few other reviews, I purchased the Highfine 2 x 2.4GHz 6dBi Omni-Directional WiFi Antenna as a Jandy iAquaLink 2.0 antenna replacement and it worked well. It was a quick replacement, albeit with a few extra steps, nothing major, but the unit was compatible and the WiFi is up and running after a WiFi configuration reset (Flip the WiFi switch when powered up on and off and then connect to the iAquaLink to re-establish your WiFi settings). A ~$9.00 antenna replacement versus a new $500.00 Jandy iAquaLink 2.0 controller.

Good quality for the money. The base is fixed and if you want to rotate it you have to loosen the screw and then rotate it. Otherwise it worked well for me.

Excelente producto, llegó en el tiempo previsto.

Good quality but the connectors weren't as shown but they worked for my project. I assumed I was receiving brass connectors as shown but instead got stainless steel! Hard to complain about stainless steel but if you are counting on brass with the removable RPSMA center pin, I did not receive that style.