SoloGood Amass 10 Pair XT60H Bullet Connector Plug Upgrated of XT60 Sheath Female & Male Gold Plated for RC Parts

I used these to replace the MC4 connectors on the solar panels for my RV system. These connectors are much better suited for systems that need to be taken down then put back up again periodically. The connectors all fit together well and form good electrical connections, as evidenced by IR camera inspection when the system was under full load. The electrical connectors here are substantial, as they need to be for the amperage capability. Please be sure your soldering iron has enough power to heat these connectors enough to form a good joint, especially when joining them with 10 or 12 AWG wire. This is nothing more than what is needed for connections that handle the specified amperage for these connectors.

These XT60 connectors are well made and work great. If you like the price, buy them.

Amass XT60 Connectors These genuine Amass connectors slip together easily and stay snug. They won't ever come apart on their own but can be pulled apart without a big fight. No tools needed. The plastic is a little bit flexible. The cover collars snap on and stay firmly attached. You will need a pair of pliers to remove the cover collars, which is as it should be. These connectors are a pleasure to use. NOW ABOUT THE SOLDERING I have almost zero experience soldering anything, but I do own a huge soldering gun the size of a 9 mm pistol. I use it to repair cracks in large plastic pots that I grow peach trees in. I expected to melt several of these XT60 connectors before getting it right. Many reviewers of knock off XT60s complained of the plastic melting and of being brittle and cracking. So, I bought genuine Amass connectors. Happy that I did 🙂. After watching a demonstration of how to solder I stripped 1/8 inch of insulation off a wire, clamped it in a vice, and melted a dab of solder onto it. It wicked into the bare wire end. Next, I mounted an Amass XT60 connector in the vice and touched some solder with the monster gun until a drop of solder dropped onto the gold-plated stud of the XT60. Held the tip on it longer and soon the solder spread into the cavity of the stud. Lastly, I touched the bare wire to the prepared stud, held the hot solder gun tip to the wire and, in a little while, the solder blended together. DONE. On the first try even! It's solid and looks good. 😁 I feel that with a proper soldering pen (that doesn’t have a tip the size of a butter knife) even a total novice can do this. Just watch YouTube demos and USE A CLAMP. This is a three handed job!

I like these plugs. I use them on all my RC’s

Excellent quality connectors. Soldered my 12 awg wiree on with zero issues. Connection is firm, but not difficult to disconnect. Very very happy with them.