Adhesive Sticky Pads For Road Reflectors | Pack of 10 | 4 by 4 inch Butyl Pads | Sticks to Street, Pavement & Asphalt | Industrial Grade Glue for Reflector Markers (Reflective Studs Sold Separately)

I bought these adhesive sticky pads to secure road reflectors along a narrow section of our driveway. I was not sure how well they would hold up outdoors with Texas heat, rain, and cars running close by, but they are fantastic. The pads are extremely easy to apply. All that is required is peeling, sticking, and pressing firmly on it for a few seconds. Once they are down, they do not shift or peel off. Even after a couple of storms and hot days, the reflectors stayed in place. The adhesive has not oozed out or left a mess, which makes them much nicer to work with compared to other cheap sticky pads I have tried. Tip: Make sure the surface is clean and dry before applying. Dust or moisture will reduce the stick. I wiped down the driveway reflectors first, then applied the adhesive. For the price, the quality is excellent. They gave me peace of mind knowing where the narrow section is on my driveway, so I do not accidentally go into the ditch, and I did not have to mess with screws or heavy-duty glue. I highly recommend it for anyone who needs a quick, strong, and reliable outdoor adhesive solution.

I used these pads to adhere bricks on the edge of my asphalt driveway. The landscaping glue that I was going to use had a warning not to use it for gluing anything to asphalt. I was looking for something that would work, and found these Adhesive Sticky Butyl pads made for gluing to asphalt. They worked great!! They sealed the bricks to the asphalt and would not budge when I pulled on them the next day. The only issue I had was I had to use two pads per brick, which was expensive, but it really did the job that I needed it for.

Always when reversing the car, I do not see my way and go off the road, and I hate going out at night because when I return, my head will hurt due to the difficulty of seeing, until my husband found the solution, and now I enjoy when I reverse my car safely and without causing harm to the car or myself, and it sticks well to the concrete floor.

The pads work very well. Just be sure of your placement before attaching them as it is a mess to attempt to move them. They work extremely well with square reflectors.

For the most part installation was easy although there was a little work at trimming the double sided sticky pads. Have had 1 pop free but won't be an issue to reattach. For the price I'm not going to complain.

These things work great. Really stand up to traffic

These worked great, in our driveway, for a short period. After about six months I noticed that all of the reflectors, not on flat ground, have begun moving. It looks like the adhesive melts during the summer months. It’s a little frustrating as now it looks like I just placed them arbitrarily, instead of straight and measured, as they were originally.

Easy to cut individual sticky pads with scissors to fit 3M reflectors that had 2 curved edges. Scissor blades cleaned up easily with a little elbow grease & paper towel. Easy to manually peel off one side of the paper protecting the black butyl adhesive and apply to the bottom of the reflector, then peel off other side of paper and place on seal coated road. Fingers stayed clean. Reflectors stuck well to the road by standing on the reflector for 30 seconds after application. To assure better adhesion, a partner drove our vehicle front tire onto the reflector and stayed in place for 30 seconds. It has only been one week since the reflectors have been stuck to the road, and have held firmly in place through mid-80 degree sunny days, through a long rain, and through moderate traffic. This is a much more affordable, easy, and clean alternative to using coal tar epoxy adhesive to apply reflectors.

Ayuda a pegar los fantasmas en el pavimento, durán y es una excelente opción si no quieres atornillar.