GASPRO 35.5 x 15.5 Inch Glass Wind Guard for Rectangular Fire Pit Table, Thick and Sturdy Tempered Glass Panel with Hard Aluminum Corner Bracket & Rubber Feet, Easy to Assemble

We are very happy with the quality and appearance

Easy to assemble & works great on propane fire pit; very heavy duty tempered glass

If you are reading this then I don't need to tell you what this does right? So let's get right to it then. The tempered glass panels are thick and free of distortions. I'd say they're about 7mm thick. This thing isn't a light weight and should hold up well outdoors. The size fit our fire pit perfectly with about an inch gap all the way around the gas tray. There are rubber feet to raise the glass about a quarter of an inch thus allowing air to feed the flames. Since glass and metal brackets don't bend, assembly can be a little tricky especially if some of the sand casted brackets a slightly out of spec. Make sure each bracket is facing the correct way, as four have threading for the feet and four do not. My recommendation is to finger tighten each screw leaving some wiggle room to get the last glass panel on. I had to use a little WD-40 to get it to slip onto place. Once it's all together, then I proceeded to tighten snugly no over do it, the screws. Install the feet and you are ready to go.

The company that built wanted a lot more money than I wanted to pay so I found this item on Amazon. I measured carefully and ordered the item. I came and we installed it in 15 minutes. Perfect!

Made my own concrete table fire pit and needed a wind block. This was the perfet size and does great with blocking wind.

This is a really nice item. The glass is thick and beveled. The quality is definitely there. The difficulty comes in two places of the assembly. First: The rubber feet. You have to use the screw to poke holes in the bottom of the rubber. So it's conical (cone-shaped). Put the screw into the opening thread first. Then push it through the rubber. Then screw it into the brackets. Second: The glass. I assembled per the instructions. Too tight, couldn't get the last glass piece in. I removed all the screws to keep the brackets loose and still could not get the last glass piece in. I finally disassembled everything and reassembled in a different order (different brackets in different places). This time, when I put the screws in, I just inserted them to make sure the glass was seated properly in the brackets - no tightening. THIS time, the glass pieces and brackets all fit together with little issue. THEN I tightened all the screws. Hope this helps the next person trying to assemble this. Obey the instructions about not forcing the glass too hard. Just disassemble and reassemble after switching bracket positions. Might have to do this a couple times, but at some point it will all fit together (albeit snugly). Then you will be happy with the item, it is very sturdy and is of good quality.

Great product.

Was easy to assemble. Looks great and keeps the flame from blowing to the side in a breeze. Glass is thick and connection parts are well made. Should have gotten one years ago.

Easy to assemble. Quite heavy so stays in place during windy conditions

Great product, really heavy thick glass and higher than my other unit Perfect size for our Napoleon fire pit Showed up fast

It fit perfectly! Strong and very attractive!

Arrived without damage, well packed, easy to assemble only took 10 mins, you might need to open the hinges just a little with screwdrivers so the glass slides in easily. Looks great and really does do the job as a wind guard, we can now use the fire pit on a windy night! ... very happy

It’s awesome and super easy to assemble.