allsun EM276 Auto Injector Tester 4 Pluse Modes & Vehicle Fuel Injector System Vehicle Gasoline Pressure Diesel Cleaner Adapter DIY Kit Car Cleaning Tool 2 Nozzles

Had a problem with adblue injector, stuck close was the error code, instead of spending 3/4 hundred quid I thought of giving this a try, a long shot but glad I did .Took the adblue injector out, found the pin outs, plus/minus, used a little 12v oil extraction pump which I had sitting around, one side to the adblue injector supply side and the other side to a bottle full of water. Make sure too use jubilee clips, to secure the pipes that come from the extractor pump.Powered this device and the extractor pump, going through the pulse settings of the device and after a minute or so the injector started to have a unified spray pattern coming out the adblue injector.Put back into the car and no more error codes, it's been about two months now. So glad I tried this, saved me hundreds.

It can unstick and clean injectors

Not a tester, rather a driver with 4 different pulse modes. Why not a tester? Because it does not diagnose your injector, will drive your faulty injector not giving a clue if is faulty or not. Wires quite short, about 40cm.

A sturdy well constructed item that makes injector cleaning much easier. However the supplied leads did not fit my motorcycle injector contacts so I had to make an adapter. It could also have done with a mode to keep the injector open for cleaning rather than all pulse modes. That said, it worked well.

1. The red and black connectors are too big for the injector plug and i had to improvise to use it.2. Those two nozzles won't fit any spray because are too large and i wasted a lot of fuel injector cleaner.3. This device came with a battery compartment on back but everything is missing, it is just an empty space covered by lid.4. Once you have selected a mode set you can't change to another one until you cut the power.So for me it is a wasting of money!

works well , but a reset would be helpfull to be able to change modes without disconnecting the 12v supply.

allsun EM276 Auto Injector Tester 4 Pluse Modes & Vehicle Fuel Injector Flush Cleaner Adapter DIY Kit Car Cleaning Tool 2 Nozzles.Works like it's supposed to and can actually be used for testing other electrical components with the same power requirements. Just know that you'll probably want 2 people to operate it!This tester can diagnose injector problems, you can use it on each injector individually to test stuck, leaking or burnt-out. Its used 12V vehicle battery as power supply. It has 4 pulse modes and in the continuous working mode , it can help you identify the injector is good or not when you switch off the engine. The lock mode can ensure the testing condition is same. It can work with any fuel pressure tester together.Modes.....Mode 1: the tester outputs 1 pulse, whose pulse width is about 250msMode 2: the tester outputs 50 pulse, every pulse's pulse width is about 7msMode 3: the tester outputs 100 pulse, every pulse's pulse width is about 3.5msMode 4: the tester outputs pulse continuously at the rate of 50 pulses per about 1450ms, every pulse's pulse width is about 7ms.How to use....Turn off the vehicle's engine.Connect Black / Red Clip to the Negative / Positive terminal of battery.Connect pulse output terminal to the fuel injector.Press the "MODE SET" key to select the desired pulse mode.Press the "PULSE" key, the tester will output pulse to the injector, and then the pulse signal.The indicator light will illuminate for indication.Specs.....Power Supply: 12V vehicle batteryOperation Environment: 0 C-40C, relative humidity <80%Storage Environment: -10 C-50C, relative humidity <85%Size: 147x82x29mm (for main body only)Weight: about 165g.What's in the box.... 1 x EM276 Professional Injector Tester1 x Carrying Pouch1 x English User Manual.Good quality and feels durable.Can reccomend, very handy piece of kit so my hubby tells me!Reasonably priced too.

I extended the power cord by about two feet and added an injector connector that fit my injectors to allow the tester to be easily used. I thoroughly cleaned all injectors from my engine using mode 4 and with one can of carb cleaner. Back-fire under hard acceleration was solved. This tester saved me from having to replace my injectors.

Pour nettoyer les injecteurs essenceJe m en suis servi pour les faire fonctionner pebdant un bain aux ultrasons

Terug retour bij overschakelen Van nummers altijd stroom afkopelen

N'a jamais fonctionné ne s'allumait même pas une petite lumière bref ne prennez pas ce produit

Bizarrement ça ne fonctionne pas avec mes injecteurs 😞

le produit a l'air bien fonctionne bien, je le recommande