Auto Ventshade [AVS] In-Channel Rain Guards for 2016 - 2019 Chevrolet Cruze (Excludes Classic Model), 4 pcs. | Window Vent Visors - Smoke | 194712

Fit was super tight and there was no adhesive on the ends so now three of them will not roll all the way up unless someone holds them out. I will remove them and attempt to solve the problem.

These absolutely do not fit a Chevy Cruze. I have a hatchback, the listing said they fit, they don’t. The window channel is too narrow. (There’s a reason weather tech doesn’t make them for this vehicle!) I hope this info saves someone some trouble.

These work perfect! I installed them today. You have to follow the directions, which to be honest, are a bit vague. Make sure when you insert the ends, that the side WITHOUT the tape goes BETWEEN the windows rubber seal and the frame NOT in the channel where your window rolls up. This is going to be in the center of the car on all windows. To begin roll down all your windows and leave your car running as you will need to roll them up later. After you dry fit, clean the window channel with the alcohol wipe. Peel the protective film off of the tape on the end and a little from each side. Do not remove it all, leave just enough to pull. Insert into the channel, start with the end that goes between the frame and the rubber seal. Make sure everything is seated well. Slowly roll up your window holding the plastic out a bit so it doesn't catch on the end in the channel. Check to make sure everything is still in place then pull the ends of the protective film from the rest of the tape. Leave the window up for 48 hours to ensure proper adhesion. Do the same for the rest of the windows. There is a video on install on the sellers site if you search for the In Channel visors. It is for a truck but you can see how they do the install. They do not show the part without the tape going between the rubber seal and frame however. I hope this helps those who have read the bad reviews and were on the fence about purchasing them.

I have been searching for the correct fit since I purchased my 2016 Cruze in 2016, these fit perfect. I seen other reviews where they say they don't and that window hits shade when rolling up. This is because it is not installed correctly. The part on the shade with no adhesive does NOT go in channel. These are perfect!

These things are trash they prevent the windows from being able to go all the way up in order to close the window you have to get out and pull them out a little to clear them wish I had of listened to the reviews telling me the same issue I have iv had some in past with no issues I wish I had just bought the out side stick on in stead of the in channel these things are junk

I love the quality of the materials. However I purchased these in July and didn't have a chance to open it and put them on until the end of August. I followed the instructions and it went seem less. However after two weeks, not two or three days, of leaving my windows closed to let everything fully seat and seal - the first time I opened two of my windows and went to close them - it pushed the plastic visor up and cracked them.Now because it's beyond the 30 day period, even though I just put them on and let them fully seat and seal and go to use them - they break - now I cannot get them replaced.Warning - these do not fit the way they say they will - and no matter how well they seem to fit and how long you let them sit before using them - they are just too tight and your window will catch the plastic and crack the visors. There goes $55+ out the window.Sad thing is if I could have gotten them replaced I would have gotten another set for my truck - because now I know that I would need to trim some of the plastic off the ends so it wouldn't bow so much pushing the visor back in towards the window causing it to catch on the window and crack it.Too bad. It seems like they would have warned you about you about that in advance as a possible fix so you don't ruin your visors.

2 of the 4 didn't adhere well. They stop the windows from going up, and have to pulled away to get the window up sometimes 3 out of the 4 broke at the back corners.

I ordered this on the recommendation from Amazon that it would fit my Chevy Cruze it doesn't I'm having to return it. It looks great but it doesn't fit.

Cracked, barely designed for the shape of my windows, overall very low quality I did not expect this from avs. Ive had avs on multiple vehicles with 0 issues. It's like they gave up when making these ones. Returned and lost a customer. I won't be back.

they fit perfect, and every store online told me they are not for 2017 cruze hatch. well they are all wrong they fit, same window sizes as the cruze sedan

Was not the right size, broke first time window was done up.

Horrible to install

Horrible product. They catch the window everytime you roll them back up. Deffinetly not engineered properly. Waste of money.