2897333 MAP Air Intake Pressure Sensor 4921322 Replacement for Dodge Ram Cummins Diesel 6.7L 1110010PA01 2897333

Removed the codes from my Dodge Ram 3500 and for a lot less money.

This MAF (MAP Sensor) isn't the correct diameter it's not a correct fit, it just falls into the air duct.The "O-Ring" doesn't seal at all.This device is the correct NUMBER printed on it EXACTLY like the OEM Sensor but it's doesn't fit properly.

The media could not be loaded. The Tmap sensor went out in my 2017 RAM 2500 and everywhere I looked was well over 280.00 to replace it. I took a 30.00 gamble on this sensor and was pleasantly surprised that it worked. After it was installed I ran a diagnostic to see if it would throw a code, it did not. To ensure everything was right with the world I unplugged it then ran another diagnostic and the codes I expect to be thrown were there. I cleared the thrown codes, plugged the Tmap back in then ran another diagnostic which was clean. Time will tell on the longevity of the sensor but for today I'm happy with the gamble and money I've saved.

This was a perfect fit for my 2016 Ram 2500HD 6.7 Cummins. Check engine light came on and code was for under boost. Change it out, problem solved

Fits perfect but it throws more codes than my factory bad one.

I had been warned about after market MAP sensors and even ended with a defective one prior to this one. OEM Mopar is $400+ so I tried again with this one looking at the reviews and the price. Got the most expensive and good reviews. It works well but still early. Power is back the errors are gone.

Rpms were 150 higher than before installing this cheapo. 850rpm is usual for my 2016 Ram 2500 6.7l Cummins. Also air movement g/s was lower than my stock sensor as read from my Bully Dog GT. And set off 4 codeback ons. Ambient air temp sensor, air pressure reading outside of nominal limits, and two more that I can't remember. Put the stock unit back on. Threw this new one away.

NOT WORKING