WINIT16A Arcade Switching Power Supply 110/220v for Video Game Cabinets Upright and Cocktail Durable New

Works great so far using in 2 barcades. One in a Soulcalibur barcade and the other in a atomiswave barcade so far I have not had any issues. Just as a tip make sure if you are powering these with regular AC power make sure you flip the little switch on the side from what it is default switched to or it will not work.

It works great, and is easy to use! I used it for an arcade build project to run all of my 12v and 5v devices inside, and connected the "AC/L" (hot wire) through a switch I installed on the top of the cabinet so I can switch the PSU on and off from there.Edit: I dropped one star because I just noticed this power supply isn't UL listed. There's no UL, CE, ROHS, or anything else at all, so just be careful. If it ends up failing spectacularly, you could be in for a really bad time if this thing is sitting in a wooden cabinet.

Be sure to switch the 220/110 volt switch when you install. Once I did that, it worked perfect!

The power supply will work fine but it was smashed in shipping requiring me to bend it back before use. Not great.

was bent in shipping but worked as it should, looks a bit flimsy - 1 star

I've built a few bench-top power supplies from ATX power supplies (tons of resources out there for doing it)When I found this for $20 USD I knew this was the way to go for my DIY arcade box, will buy it again. Keeps the cabinet clean, pro looking, 12v & 5v, regulated power ..... it wont replace my bench-top power supply unit, but it will be my go to for larger animatronic builds and other game cabinets

The 5 volt lug only Produced 4.5vdc with voltage adjust maxed out. Tried disconnected and under load (standard JAMMA board). Also, it felt really cheap. The housing was flimsy and the mounting tabs bent very easily. Not worth the price at all.

Item as described. The only thing I noticed is the -5 volt output was a little low. If I adjusted the pot to bring it up to the full -5 volts it seamed to get hot or smelled like something was hot. So I turned it back down. Other than that it works great. I bought this because I needed +12V, +5V, and -5V to read some old arcade eproms.

Works well, not exactly what I needed, but close enough I could make it work.Product works well.

This power supply worked well, don't take me wrong. But they are no protections against mishandling. If you do a small mistake, it may brake. The fuse may not do the job.

Stable et fonctionne bien

Works great