80mm Moisture-Proof 12V High Airflow Cooling Fan 2Wire 3Pin 3500RPM 2-Pack | Compact IP44 Square Fan for High Humidity Areas & Equipment Cooling - PC PSUs, Incubators, RV Fridges, Underground Garages

I used these to make a circulating fan for my Rv frig. Easy to do and 1/3 the price of a premade unit. I power them of the light switch wires. Easy peasy. They are quiet and move a lot of air.

Forgot these fans due to the price and for a replacement fan for a welder. I hooked them up and they work perfectly. Fine dent. Have no problems to plug was different. So I had to splice the plug but I knew this when I ordered the fans. They also didn't lineup with my welder. Screw plugs, but I also knew this as well. And they push plenty of air and seemed to work. Great, so far, my welder has not overheated.It has been running perfect with these fans

Was An Exact Fit But Very Noisy. Had To Drill Out Holes And Use Stainless Steel Bolts Due To Lack Of Parts On Hand. Had To Cut, Solder And Sheath The Wires Due To The Fitting Being Different. Overall If You Are Mechanically Inclined Just Another Install. Too Early To Tell The Longevity Of This Product.

Perfect

For it to be a small fan, it worked good on the application on my boat.

I needed a cooling fan for a $1,340 radio/GPS in a motor home that burnt up from the heat in storage from the unit being mounted just under the windshield. A lot of heat even stored indoors. I purchased one set of computer fans that the wire was to thin to connect to any type of power supply. If the wire was that thin, I doubt the fan would last long. I purchased these, they wired up perfect. A piece of 22 ga sprinkler control wire plugged into the plug for a perfect fit. That connect to a fuse protected cigarette light plug and I now have air circulation 24/7 while in storage. The come with protection cover that are nice for tight spaces like I have. Fans are quiet and move air nicely. A perfect fit for my needs with one to spare.

Worked great allowing me to replace broken cooling fan

The fan in my commercial drink fridge blew. Wanted to get the correct A and V for match for a replacement. This was the best I found, but only came in a 2 pack. What am I gunna do? Waste a fan? Cut another hole and wired them both. Had to turn it WAY down from original 1 fan setting after putting both in. These things BLOW.. in a good way. Ice cold fan gold right here.

I bought these fan to replace the fan of a Pestrol outdoor insect trap. The fan of the trap had seized, as insects had gained access to the electric motor. These fas look near the same as the replaced fan, and also show an air gap of about 2-3 mm around the fan axis. The motor is directly visible and accessible through this gap - for moisture, water, and insects. I cannot judge whether the exposed electric components of the motor are waterproof themselves, but certainly the moving parts are not protected from water ingress, or from insects crawling into the space. Thus, only 4 points. Just one month after replacement, the fan continues to work as expected. The original fans of the Pestrol trap worked for 10 months (#1, replaced under warranty) and 12 months (#2, out of warranty). Only time will tell for how long fan #3 will survive..

The price was in my budget and especially since it was for two fans, but surprised that it was two boxes with two fans in each box. The plug that it came with wasn't of any use to me but the lead wires were quite long.

Not sure, if this is gonna be helpful to those looking for a fan. I bought them to increase the airflow to cool down my rv fridge. The install was easy and still waiting on the outcome.

only need 1 but thay sended 2 so you have spare

I installed two of these in front of the heat sink inside my RV propane refrigerator. Reduces propane consumption, evens the temperatures inside the fridge. Very quiet, draws almost no current. Great price, used for one season and very pleased with them.