80-47435-01 AquaT Compact Standard Electric Marine Toilet, 12V, White

I got this last season and have nothing but good things to say about it...it installed like a breeze and has worked on my busy fishing boat...Good product.

The install was easy and it works wonderfully! There were many more much more expensive options out there however this one is built well and one press of the button and your toilet is flushed. We had a manual toilet before and it was a lot of work just to use the bathroom. :)

This is a great buy for the money. Super quiet as well !! I did however purchase a ribbed fitting for the waste line at West Marine to form a better seal as the provided one leaked. $8 part

Easy install and it works great, once I got the kinks worked out. Make sure your wiring is good, any drop in voltage will reduce its ability to pump to the required height. I have used it now for the full season and cannot complain. The bowl is a bit small though

For the money this can't be beaten, reading some of the reviews before I purchased , gave me the impression that it had some flaws. I upgraded my porta potty sea ray head to this electric toilet. Not an easy task as there's a lot of work involved with fresh water and black water holding tank installation in a boat model where such option isn't offered by the manufacturer. So took a chance, set up a temporary system and bench tested the unit before doing the full install. I found that the suction bringing the freshwater in was fine and the outlet shredded the toilet paper fine and worked exactly as it should. Yes it's a little loud, but hey when you use a toilet on a boat everyone knows anyway 😉. So did the full installation, hardest part is always the large sanitation pipes as they are awful to work with. But this unit works fine with no issues , the bowl clears of water with the flush and so no water slipping around on the ocean. See video for operation, like anything it always sounds louder on a video, but the noise is more than acceptable and the plastic seat seems fine. Just make sure the gripper clamps on the hoses that are already attached are tight, as is the union fitting.I made some mounting plates from marine board, so as to ensure a firm fitting, just using self tappers to Mount to the boat shell I fear wouldn't last long. Hope this review helps others, but I'm completely satisfied with my purchase, obviously time will tell.

Only thing I didn’t like was you had to place flusher on wall

The seat uses a plastic bolt/nut arrangement. Before I could get the left nut snug enough it started stripping (popping out of the thread) - and I was just using my hand (no tools). As a result, the seat isn't positioned exactly over the bowl - very annoying.I don't recommend this toilet if your plumbing arrangement uses a pressurized water source. If you do, you will need a solenoid water tap to stop your house water from filling the bowl and running over (the head does not stop this) - this is something you have to add and wire in yourself.The lack of a water-only button prohibits flushing the system without running the macerater, and the lack of a macerator only button means you are drawing water the whole time if you things back up a little bit.I used my old Jabsco controller, along with a Jabsco solenoid switch, to solve that problem. It's an inexpensive head, and you get what you pay for, just understand the limitations.

The media could not be loaded. Not so loud, works great