Eightwood Aluminum Box Electronic Project Enclosure, 4.32 x 2.82 x 1.13 in | Extruded Aluminum Case with Built-in PCB Slot, Sliding Cover

Very nice enclosures especially to keep RF in or out of your electronics.

I used it to mount control boards for PWM fans on a firend's golf cart. Looks like a professional installation but done by an amature.

Needed a box to make a bench harness for PCM programming and this one was the perfect size. Love that it's aluminum because it's easy to machine yet sturdy.

Excellent construction.

I'm giving this five stars for being conductive and easy to drill through. No need to run shielding wires inside.

Very good project box: 1. This box is very sturdy when assembled. 2. It can be opened in a couple of ways - either take the end off or take the top off 3. The end pieces are thick enough to mount switches, jacks, etc.

Screw broken off, no way to contact seller to get replacement half.

Ok, it's an aluminum box. Workmanship is good, but not perfect. The end plates are just 'slightly' larger than the box they screw onto. This could lead to scratches on whatever surface you place it on. A tiny bit of machining is in order, or put a few rubber feet on the box. The screw holes on the end plates are 'almost' perfectly aligned with the channels on the box, but not quite. The screws still fit. Overall I'm pleased with this box.

Small but sturdy project box - easy to tuck away for an unseen coverup. The way it goes together is help in placing the box - the top can be anchored and the box assembled to it.

Just right for my project.

It is what I expected.