TapMagic 16 oz. Can New Improved Cutting Fluid

used for plunging and turning cuts so far! Excellent results

This stuff really makes a difference. I used to use PAM cooking spray as a cutting fluid, and it did well, but this stuff is great, not only in cutting threads, but also when drilling holes in steel as well.

Works as described

Used with annular bits and worked great

Saves on drill bits and sharpening!! We got involved in a project that required multiple 1" holes (over 2k holes) in both steel and aluminum (up to 3/8" thick) and we went thru a few bits before getting this fluid. Now, we can go thru 4x the amount of bits before replacing since it keeps the temps down on the bit. We've saved tons of time and money not buying new bits and sharping old ones

Used by an electrician to drill holes in metal panels. Works well but smokes a lot even at low rpms kicking off chemicals that I felt in lungs later. I just use canola oil now, doesn't smoke as easy and no chemicals.

Good oil. Protects Taps and Die sets from wearing out.

Great because it’s thin and works well. Goes where you need it. Lubricates the die or tap very well.