Ice Cube Tray, Silicone Ice Bucket with Lid, BPA Free, 2 in 1 Portable Ice Cube Maker, Ice Cube Mold Genie for Frozen Whiskey, Cocktail, Beverages, Blue

The lid, major design flaw. The lid does not screw on, which means water pushes up on the center insert popping the lid off. Any water that escapes goes into the middle of the center insert or spills out in the freezer. You can get around this by getting creative of course, hence 3 stars instead of less, but they should have threaded the lid to screw on. Even if it was a simple quarter of a turn, it would be enough.

Once you fill it with water which really needs to be added from the side (carefully as there's not much space to run the water into the form) it's very hard to keep the top on as it doesn't screw down and the interior of the mold wants to push up as it floats in the water. It works but it IS TEDIOUS.

Love the idea of this however when you add water to it and put the cylinder in and push down and then put the top on after you release it the top comes up and so does the cylinder and all the water goes to the bottom and there’s a big brick of ice at the bottom all the time. Not what I expected

The lids won’t stay on unless you put weight on them. Takes a bit to get the inner liner out with warm water and not all bubbles will have ice. These are ok if you just want a little ice or it will take along time for a lot of ice.

What they don't show you on tik tok is how difficult it is to get the middle plastic slip to stay inside without the water trying to lift the inner cup out. Makes about 1 cups worth of ice also

I’m not sure if I’m not using this right or if it’s just not as easy to use as described. On the plus side it does make nice little ice cubes but it’s hard to fill without overflowing and difficult to open so you can take out the ice cubes and make more.

Top didn’t stay on. I would have to sit something on top of it and order for it to stay while it was making ice

Very hard to fills and takes up to much room in my freezer draw