Adjustable Satellite Dish Antenna Mount for Roof or Wall Installation, TV Antenna Mast, J Pole Mounting Bracket Weatherproof, Hardware Included

This thing went up in no time. I mounted mine a bit differently than in the photos, but it still seems rock solid. The only thing I wish it included was a set of tar pads to seal up any potential leaks. Was able to find some here on Amazon (https://amzn.to/33X8sIB) to use.

I very much like this product, it even came with lag bolts. In fact I didn't see any downsides to it. It was easy to set up and can be used as a wall mount or a roof mount.

I have an FTA dish that is having some difficulty staying put. I'm hoping that the use of this three leg mount will help to hold the dish in place better, especially during high winds. My original setup is also troublesome in that it gets out of level, again hoping this will work to resolve that problem. At the least it'll be easier to adjust it back to where it needs to be if it does get out of alignment. The unit appears strong and though smaller than I expected, it says it's designed to handle a dish the size I have. For the price, it can't be beat.

I used this mount, along with a couple of feet of PCV pipe, to mount a 2-meter/70cm Archer J-Pole for ham radio use. Installation was pretty easy (though I needed to get my own bolts to address my mounting method on the overhang of my rooftop eaves), and it's seriously sturdy. One could easily mount a modest vertical like a CP6-AR to this. Recommended.

Glad I read the other reviews for this as the width is not 2 inches. Worked perfectly for what I needed it for though. 1 1/4 galvanized pipe fits perfectly into this mount and starlink gen 2 (square dish) fits almost perfectly into 1 1/4 pipe. Just had to put a small set screw through pipe into dish mast to keep it from possibly spinning. The mount is very sturdy and seems well built.

Compact size work as described easy to assemble and install. This is a very durable mount. It’s now almost 2 years old and has been through 2 hurricanes. Last year was over 100mph winds and was watching Amazon prime the whole time. So it safe to say it works very well. 10/10 would buy again. Worth every penny spent.

The mast for the new rectangular Starlink dish is smaller than the old round dish (1.3" vs 1.4"). Therefore this mount does not work without some sort of shim to take up the considerable slop in the fit. Otherwise it's a nice, solid mount.

Used this to install a Starlink dish. Used some plastic conduit to shim it together and recreate the factory Starlink fitting. Would have saved time and money to just buy the factory mount. Good mount tho.

My roof was 12/12 pitch so the volcano mount from Starlink wouldn't work. So I used this mount and drilled out a 3/8 bolt hole to fit Dishy in. Added some tar backing to help seal the roof and all went well. Solid pole that's for sure.

Average antenna stand.