APS Premium 4in Black iBoard Running Boards Compatible with Toyota Tundra Double Cab 07-21

They hold up well to road salt in Wisconsin winters. I've had other brands that look like hell after 1 winter.

I bought these running boards to install on my 2014 Toyota Tundra Double Cab. They were packaged well and included exactly enough parts to complete the job. The instructions were detailed enough to easily complete the job. The install was incredibly easy, and took me and one other person about an hour to complete. Like any install, there is a small learning curve, so the first running board took about 30 minutes to install, and the second about 10 minutes to install. The remaining 20 minutes was prep, unboxing, and counting out bolts and washers.One important step to follow: leave the brackets loose so that you can first tighten the boards and then the brackets that attach to the truck. Doing it this way allows you to make sure that the running boards run parallel to your truck and look good. The brackets won't appear perfectly square from below, but looking at the truck from the side will quickly let you know that you did it correctly.They are sturdy and appear that they will last the life of the vehicle. It was raining the day we installed them, so later in the day I was getting in and out of the truck with wet feet. The boards provide enough grip that you won't slip.One thing to note, the section sticking back toward the bed past the back bracket is not strong enough to stand on. I tried, thinking that I might be able to use it to reach stuff inside the bed. It immediately began to flex in a way that felt unstable, so I immediately stepped down.In conclusion, I am incredibly happy with my decision to purchase these running boards. I am the type of person that spends time researching and looking at different items before I decide to purchase, and I'm happy I decided to go with these. They look good, feel good, and were a very simple install.

I really like the running boards. I really don't need them, but it helps my dad get in and out of the truck much easier. It should take about an hour to install after you prep the mounting bolt holes under the truck. Take care not to over-torque; you will pull the square-head bolts through the bolt slot on the running board; oops. You just need to snug them up because you have locking nut hardware that comes with the running boards. If you do, just go to home depot or lowes and get hex heads. They'll easily fit as well. You might need to cut the excess threads afterward, but I didn't.

Good product at a great price. Two things to note: 1) when installing the running boards, there are 4 possible factory slots to install the three brackets. The picture above is what I went with and I believe I chose the correct placements. The front and rear brackets are obvious, but you need to make a choice for the middle bracket. Hope the picture helps.2) The front bracket on the driver's side was about 3/4 of an inch too low when installed and would have made the running board "droop". I used a jack to gently bend the bracket into the proper position. Worked fine, but I mention this as I read at least one other review that noted a similar issue. Bottom line: I am very happy.

These are a nice fit and are great for me and my wife, both on the short side. They seem study and look great. The only problem was the instructions. It is easy to confuse the center and rear brackets on both sides. The instructions say "see figure" but the pictures are washed out. I noticed the brackets are actually stamped with PC for passenger center,...DR for driver rear. Great. But why didn't the instructions mention that.. it would have helped. Anyway I like the steps.

Arrived on time and in sturdy packaging secured with packing tape and straps. Install instructions clear and easy to follow with all needed hardware (not tools). Installation was simple and completedwithin an hour. Be careful when tightening the bolts on bottom of step(s), over tightening with a simple socket results in the “metal” being broke apart from the pressure.

Update:After just over a year and a half the powder coat is peeling. I live in the northwest and drive through lots of snow. Boards are still study.Nice aluminum running boards good and sturdy. Took about 30 minutes to install. I was looking for a running board that didn't look clunky and these do just that. Installed on a 2019 Tundra TRD using factory installed locations. Very nice product.

Bought these because of the low price and wanted to get rid of stock ones. Work great and look sharp for price. Only thing I didnt like is my stock ones have four brace points or brackets per side and these only come with three so not quite as sturdy. But for price you cant beat it!