Kemimoto X3 Clutch Cover Pin Kit Maverick X3 Quick Release Belt Cover Tool X3 Clutch Cover Gasket Compatible with Can Am Maverick X3 2017 2018 2019 2020 2021 (Pack of 11) OEM #715005045

Pas encore installé mais l'ensemble semble être correcte.

These make changing the belt on the trail or in the dunes so much quicker. Dealing with the factory bolts is a PITA. Install can kinda be tricky getting everything to line up but these are definitely a must have next to a quick change belt tool.

Was very is to install I think it going to save some time when it time to change belt and clean

This kit comes exactly like the picture. All of the items in a bag and that’s it. I installed this on a 2019 maverick x3 x RC turbo and in chassis. All of the items are nice quality like all kemimoto items, BUT getting the studs installed is not easy. I tried one by hand and with small tools. It wasn’t a fun time. I ended up putting the studs in a right angle drill, tighten the chuck snug and this worked best. You can then adjust them with a small punch through the hole. The fitment is good, just make sure your studs are straight during installation. Definitely makes it quicker to access your clutches and belt, all you need is a screwdriver to loosen the hose clamp, pull the clips and the cover is off.

No directions included but if you have any mechanical skills, this should not be a problem. I chose not to use the washers when riveting the lanyards to the cover (not enough rivet on the other side i felt). Take your time and figure out which direction your cotter pins should go before riveting the lanyards. The pins that you thread in are a little tough but i feel confident they will not come out, i used a small allen wrench to thread them in and just went until they the threads we all fully engaged.