XAVSWRDEWoodworking Protractor 10cm Stainless Steel 0-180 Degree Angle Ruler Detachable Rotary Round Head Protractor Universal Goniometer Angle Finder Tool for Carpenter Painting Drawing Measuring

Arrived on time the screw nut to secure the angle set at does not tighten so it will move if you are not carful but it’s not a lot of money.

Note to maker... replace screw fixture to one that holds in place...

Nicely made and very solid. Highly recommended

Well it's relatively small and straight out of the bag looked like just what I needed for some smaller woodworking projects. But I set one or two common angles and just by eye, it looked off. Set to 90 degrees it is visibly out by a couple of degrees - see my photo up against a engineer's square, in case there's any doubt. I think that it's probably just a case of the scribe line being in the wrong place, so as long as I remember to knock a couple of degrees off the angle I need it should still be useable. Hilarious that they can't even get a right angle correct with this thing, quality control non-existent.

Quality piece of kit.

Does the job but fails to lock.Markings are smudgy and not fine enough.Did what I needed it for but expensive for the quality.

Precision is paramount when making quality products. The protractor and rule are accurate in measurements but the lock nut is quite frankly useless. If a craftsman can’t lock a measurement into a tool how can the same angle be used on multiple stock faces? Without an effective lock nut, the tool is useless.

Nice little device. I needed something small to set up angles for my knife sharpener. This is about the right size and nice and easy to use. Does the job a treat. Worth the money. An excellent little tool.