100 Pack Of Black Screw Mounts, Zip Ties Up To 0.35" Wide, Saddle Type Zip Tie Anchors

Can’t beat these. Nice quality, seem tough. Time will tell, but happy with these now

Arrived on time and was well worth the price.

I purchased these AFTER purchasing the larger GTSE 100 Pack Of Black Screw Mounts, Zip Ties Up To 0.35" anchors. I purchased the lager 0.35" anchors because of reviewers claiming that this 0.2" anchor was either a little too small for the zip ties they were using or the screw hole was too small and the screw head would poke up into the channel where the zip tie goes interfering with using them easily or not at all.When I received the 0.35" anchors, they seemed huge to me, and way larger than what I needed for typical zip ties and screws. So I ordered these 0.2" anchors anyway and "gambled". These 0.2" anchors are fine. I'm using what I consider typical zip ties: black, UV resistant 8 inch 50 lb cable ties. And I'm using what I consider typical screws: Grip Rite exterior grade screws (similar size to sheet rock screws). Again fine. The screw sits in the counter sunk hole and doesn't extend into the channel to interfere with inserting the zip tie. I'm using these to mount rope lighting. These 0.2" anchors are at the limit for 50 lb cable ties, and if using stronger cable ties you probably will need a larger anchor.If you are using some of the newer reusable cable ties (and they are cool), those are wider and would need a larger anchor. The 0.35" could probably accommodate many styles of the reusable cable ties or the heavier duty cable ties, they can even be used with the typical 50 lb cable ties, there will just be some slop in the channel where the cable tie goes.Overall the quality seems acceptable.

All is well used on electrical wire

This product is excellent, especially in limited spaces where you can't use the sticky pads normally used.

Good

These are easy to use and easy to anchor/mount when holding Power Cables tight to the chassis of my truck.

I purchased the GTSE black screw mount to support relatively large electrical cables in the 12v DC wiring system on a boat. Insulated tinned copper marine cable - 4/0, 2/0, 1awg, 4awg. In the Amazon posted picture it shows the inner angle brace section of the mount between the horizontal and vertical being a smooth transition - angle brace meeting the top of the vertical section. In the mounts I received the angle brace section did not completely reach/meet the top of the vertical section - it was below it - and thereby created a 'hard corner'. That hard corner would have the potential to compromise - dig into and through - the insulation on the large cables over time. I couldn't take that risk, so I returned them. I subsequently found/purchased a black screw mount with a 'saddle' that holds the cable that is smooth and without 'hard corner' that would dig into any cable insulation. Hopefully this review will get the seller to post an accurate picture of what's being sold as this mount would probably work fine for smaller diameter insulated cables.

Produkte Stimmte genau mit der Beschreibung überein. Schnell, zuverlässig jederzeit wieder

Gebruikt om netwerkkabels te ordenen.Er passen er makkelijk 2 binnenin naast elkaar van awg23.Uiteraard kun je er ook meer vastzetten.

Un prodotto innovativo e funzionale

used these in the garden and they work a treat

Un semplice supporto per fascette da fissare con tassello..Robusto e nella sua semplicita' molto utile.Sicuramente piu' pratico dei supporti gia' comprensivi di fascetta molto piu macchinosi e da gettare in caso di forzata riapertura o taglio della stessa.Qua' invece si sostituisce la fascetta e se ne mette una nuova senza rimuovere il supporto.