LET'S RESIN Multi-Facet UV Silicone Quartz Crystal Molds Pendant

The various sizes of this mold set is amazing. Very easy to use. Can be a bit difficult to remove on the ones with double points. Cleaning can be hard if you have thick or large fingers. Lots of uses from using as physical game loot with table top RPGs to simple pendant necklaces. The posts for the holes to make jewelry out of are not very large and either needs to be drilled to make slightly larger and/or to fully open the hole as the post in the mold is too short.

I was asked to be part of an art installation coming up this spring.The only issue was that my art is normally big stuff. This install requires that every piece of art fit into the diamond of a City owned Chain Link fence. Hmm. What to do?I got same of my smallest items and modified them to fit and they look great. I had never done jewelry before but thought I would try these. When I posted the to the other artist, they all said to make a bunch of these to add sparkle to the whole installation.I'm getting the hang of it now and it's fun.The molds are thin but have their one built-in stands to assure the opening is straight up. Most have a pin to create a hole for the wire but I would almost rather drill my own. They do work nicely though.Air does get trapped so I suggest you fill to just above the tip and then use a toothpick to pull the bubble out. Doing that, I had zero bubbles.If I do start selling them I will sand and polish but for the installation, I just used my trimmer to shave the fill line. That way it keeps the full sparkle which is what we are gong for.I am really happy with these and as long as you drop them into a warm soapy water bath to remove they should easily get 20 pours out of them. So far I have 5 ours out of them and have yet to break one single hole post. I know that will happen soon but not a show stopper.

I absolutely love these little molds. It does take a steady hand and a thin stream of resin to pour into the smaller pieces. They turn out shiny and sparkling. Make sure not to over-fill the mold because if you have to sand off the extra resin, you will lose that shine. They have built in holes for hanging. I am using them to make suncatchers with pretty gold chain and 10mm jump rings. They are easy to demold.

these were some pretty decent molds if i’m being honest. they are pretty easy to de-mold, and they don’t get very dirty. but, on some of them, it’s hard to put the resin in. if you are looking for molds that can do you beginner work and are somewhat easy to use, this product is perfect for you.

This is actually my second order of these. They worked so well that I wanted to be able to make more at once. They are a good size and the size variables match up really nicely. There are ones with flat bottoms that I use on crowns and ones with pointed bottoms I use for earrings and such. Very easy to remove dried resin. Definitely a great buy.