PEC Round Bar Center Finder MODEL: #4200-100

No love in making this, i bought this one because PEC has a good reputation for atenction to detail, so i was greatly dissapointed that the center marking was way off center. Sure it will work, but to have such an oversight in quality control is worrying

It works just fine and shipped on time good packing easy to use and priced right for the home shop this tool was fun to use

Extremely inaccurate and very poorly made. This is supposed to be made in the USA, but considering its poor quality I think that it is doubtful that it is made in USA. Purchased to use with my milling machine to quickly estimate the center of round bar for drilling. I did not expect extreme accuracy, but it is so far off true center it is useless.

Wildly inaccurate as delivered. Off center on a 1 inch bar by .020 inches. You can see that much with the naked eye. By grinding the point of the "Y" arm to shift its location, acceptable accuracy can be obtained, but that should not be necessary. Probably should have given it one star, but since it was fixable it got one star

The lines to indicate center is off. I could see it with my eye. Double check with edge finder on the Bridgeport. A little over 1/16" off of center.

Works as advertised.I'd buy again.

Low quality stamped blade riveted to shank too tight. I have doubts about its accuracy.

It's cheap and you get what you pay for. Stamped center on the one I ordered wasn't in the center!

For the price it was well worth it, used it a couple times already.

The marks are off making it imprecise. Your can still make due by eying the centre of the tool

Quality is poor. Delivery was good.