Art3d Decorative 3D Wall Panels Big Wave Deisgn, 31.5"x24.6" Matt White (Plant Fiber-3)

يجنن المنتج خذيت كميه صغيره اجرب وطلع يجنن بس للاسف يوم رديت اشتري رفعو السعر للضعف وتوهقت مش قادره اشتري

We had an accent wall at our airbnb, that was covered in brick wallpaper. It needed some modern updating and I came across these on Amazon as a solution. It took me about 2 days on and off to install them. I went with the plant based tiles, and while I like them, if I had it to do over I would go with the pvc option. The plant based tiles have a very comfortable finish, it really looks nice, and matte. They are basically a very nice, hefty cardboard, and I can see them taking stains and damage easier than the pvc option. With the plant based tiles too, I would be very careful about painting them, a light coat of paint or primer before hand, is probably a good recommendation. I can see them soaking up a ton of paint, becoming heavy, and not sticking to the wall. I used a contact cement and it worked well for sticking the tiles to the wall. Things that I did not think through that I should have before installation. You are going to want caulk between the tiles, even if you run them very close. You also want flexible caulk that is not going to crack. Have a good solution for cutting the tiles. I thought I could use wood saw and jig, but it did not give a clean cut like I wanted. I then tried metal cutting snips, and while they work for very small cuts, they do not do well for long cuts either. I ended up using a cutting wheel on a Dremel, and it did pretty well, I sanded and cleaned the edge a little after each cut. If I had it to do over again, I think a table saw and very small tooth blade would be the easiest and give you the best looking cuts. You are going to want to frame in the edges of the wall you do with some type of base board, I used 1/4 white square, and it worked well. If you don't, the edges of the tiles that meet the wall are not going to look good. If you have outlets on the wall, have a plan in mind. I cut out perfect holes in the tile for the outlets, then 3d printed some little riser frames to go under the outlet face plate. Also if you plan on going around a corner, this may not be the product for you, I recommend this just for an accent wall. I can think of solutions to get around corners, but it is going to complicate the job significantly. Overall very pleased, it looks great. It also looks way more pricey than it actually is. You will most likely spend the same for instillation materials as you will for the initial tile purchase, so keep that in mind.

Hola, me hacen falta 3 piezas. Me las puedes vender?

looks great but if you go into a corner it is hard to work with. best on a flat surface

excelente

I spent a lot of time looking at different wall panel decorations for my project. This plant fiber paneling was great, especially for this low price! Much lighter weight than pvc, so it was easier to handle. I liked the flat sheen of this vs. pvc, so I was able to paint with paint brush instead of spray paint, but spray paint would have worked fine too I'm sure. I used gorilla spray adhesive to stick to the wall, then caulk between the edges. A few things to note: One, It does take a long time to install. With adding the spray adhesive, lining each panel up, caulking and painting. Second, these are like a thick, hard cardboard. Good quality but they will get damaged, especially the corners, if handled too rough. Good thing I had a few panels to spare to experiment with. Third, after a few days after I finished, there is some movement with the panel touch each other, so you can see the panel edges separating a bit. I fixed it by reapplying caulk, and then painting again. All in all, I'm very happy with the results!