Orion Motor Tech 16pc Blind Hole Bearing Puller Set, Bearing Race and Seal Puller Extractor Kit with Slide Hammer Counterstay 3 Adapters 6-59 mm Collets, Inner Blind Bearing Removal Tool Set with Case

Essential item in my garage now following complete bike rebuild including virtually all bearings. A few tips and techniques had to be learned to get the best out of it but overall very positive and good value.

Bought this to remove half shaft oil seals . It took longer to remove the plastic film what the case arrived in than it did to remove the seals good tool easy to use and does the job

Done the job required - knock out bike steering bearing outer race

Got this set to help with removing a wheel bearing from a small passenger car. This tool was not only difficult to try and set up to use, it's also no where near strong enough to handle the pressure required to remove a wheel bearing. The hardened steel bent under the pressure while using a socket wrench to turn it, which rendered the tool unusable after the first try. I ended up using a shop press to remove the bearing which made the job so much easier. I couldn't imagine wanting to use this tool for any type of repair job in the future. I just don't trust it. I have submitted a return request.

Worked fine, good tool to have around.

Excelente producto lo mejor para sacar bujes de sigueñal

I give this product a 5, ONLY for the design of it, the real disappointment is the number of reviews This OMT product made me very disappointed. Did not expect these type of issues from OMT. The 1st set I had to turn back in for defects. However, this 2nd set is actually worse. The first issue are the diameters of the collets themselves, most were undersized .8mm to 2.2mm. This affects the working range where it was impossible to remove a bearing, one too big, the other to small [1st kit]. Another problem, second issue is the cutting of the collet face itself. They are not 120 deg apart or offset from one another. This causes the collet not to open evenly, more like egg shape [5 of 10]. Thirdly, is the Pin Bolt, they are not heat treated hard on the tips that spreads the collet. Another issues of egg shaping. As per pic, these Pin Bolts where only use once to test the collet spreading and return to their retracted position [all were used to open the collet to 60% of max or approx half way. One could only imaged what these tips would look like after a dozen or less usages. All I can say, this collet set will deteriorate rapidly. Maybe others have had good luck. However, from what little I use it, I would NOT recommend this collet puller set. Hope this helps you.

Está macizo, funciona muy bien para sacar baleros internos, el precio de 2,000 se me hace razonable.