How to use, plsese follow the steps: 1.press the nuts to the slots on both sides of the idler 2.Ensure both bearings are inside the pulley! 3.Insert the pulley in idler as shown in the picture. 4.Slide the shaft through the idler and pulley.Use reasonable force or you will BREAK the printed part. 5.Place your finger on the bearing and ensure it can rotate freely. 6.Insert both bearings in the pulley,Be aware that bearings can slip out during assembly.(Layers might be visible in this printed part due to the geometry .The functionality and strength remain unaffected) Package includes: 2 x Drive Wheel (Without screw hole) 2 x Drive Wheel (With M3 screw hole) 4 x Bearing 4 x M3 Nut 2 x Drive wheel shaft 1 x Allen wrench
M**Y
Not useable for prusa mk3 besr
Purchased to use on prusa mk3 bear because I couldn't find my original Bondtech gears, the gearing meshed together nicely but we're unusable due to gear length being slightly longer than the genuine Bondtech gears, the shafts were also not cut very straight or cleanly.
Trustpilot
1 day ago
2 weeks ago