TRUE MODS 4-inch 60W LED Fog Lights Replacement For 2007-2018 Jeep Wrangler JK Unlimited JKU Sport S Rubicon Sahara Front Bumper Off-Road Fog Lamp Round Driving Light Bulb Accessories

I recently switched my 2006 Chrysler PT Cruiser which did NOT come with fog lights from the factory, to having fog lights. I didn't want to have additional programming done nor did I want to install a new light switch lever so I did the harder and slower way of wiring in my own relay and wires and switch to the dash. Once this was done, I hooked up some OEM's to ensure it worked and it does.Now, the fog lights. I always knew I'd be switching to halo fogs and I spent a long time looking and comparing various products. The nice thing about Mopar is a lot of parts are cross compatable, these fogs work even though they're for Jeeps. Wiring them in was easy, though as other reviewers have mentioned - the connector is reversed, so the latch is on the wrong side. This is fine, I added some additional electrical tape to secure it. Adding the DRL and switch back turn signal was easy, plenty of color coded wires included. I had a lot of spare wire. I used high temperature conduit I bought from Autozone to route my wires and protect them from engine heat and weather, and ran them behind the wheel arches. I DEFINITELY RECOMMEND ORDERING WIRE T-TAPS. I color coded my wire t-taps, and tapped into my DRL and turn signal wire without needing to splice anything. I already have LED headlights, DRL's and switchback blinkers so these are a fine edition. I did not experience any hyper flashing or anything like that. They look awesome, and are very bright. Much brighter than OEM.Now, here's the con. The turn signal flash, is out of sync with all of my other turn signals. These flash about half a second sooner than every other light on the car. Whilst not a dealbreaker, it's quite annoying. I may do a video and add this to my review at a later date. I also was not aware that there is a slight red tone of light to the fogs when just the DRL is running, I have no problem with it, I kinda like it. Would have been nice to know though (unless I missed it when I was looking at the listing).My overall rating is still 5 stars. The product is high quality, plenty of wires and connectors in the box, and drop in for OEM as well as it's easier to adjust the position on these than the OEM. And they look awesome. If you're thinking about buying them, then you should just buy them. The switchback feature is optional - you can just skip connecting the orange wire.

A few things here 1 is in order for the lights to work on my 2014 jku the plug had to be reversed red into black and black to red for lights to work... don’t know why but that’s the truth! Also had to tape the connectors together cause they won’t snap together that way! Also have no idea I’f there is a right side and a left side light.. there not sitting totally flush in the holes like the factory lights do!!

Someone else left the same comment...the connector from fog light to the factory plug on my Jeep had to be reversed for both lights for the outside clip to lock in. It left a little gap on side because of notch on side of clip. It worked but was not the way it was supposed to go.I’m a little concerned about how good of a seal it will have long term. I would like the manufacture to redo the wiring connector and resend just the connector. Please let me know. Thanks

This is the second set ordered. One of the fog lights quit operating a little less than one year after installation. Since they're not available in singles, a second pair was ordered. Other than one of the lights quit operating, I'm very pleased with the installation, fit, and brightness of the fog lights.

Yes they are very bright, and well built, but the the light throws a very short pattern out, not usable in the real world. And they not Osram branded. Osram is a well know company that makes Silvania.